Pioneer BDP-05FD Check the settings Select Proceed, then press Enter, Output test tones

5Select and set the HDMI High-Speed Transmission setting. Use / to select, then press ENTER.

TOP MENU	TOOLS
	ENTER
HOME	RETURN
MENU

Setup Navigator

BD PLAYER

Select the HDMI Hi-speed transmission setting.

On Off

Normally select [On] (Recommended).

Select [Off] if the video or audio of HDMI-connected

was not output in the test output.

•When HDMI High-Speed Transmission is set to On, use a High Speed HDMI™ cable. The picture and sound may not be output properly if any other HDMI cable (standard HDMI™ cable) is used.

•When HDMI is selected for Video, proceed to step 8.

•When Component Video is selected for Video, proceed to step 6.

•When S-Video/Videois selected for Video, proceed to step 7.

6Select the output video resolution from the COMPONENT

VIDEO output terminals.

Use / to select, then press ENTER.

Setup Navigator

BD PLAYER

Select the output video resolution at the

Component video terminal.

If you select [Source Direct], the output resolution is determined according to the video format of the playing source.

For details on the resolution settings, see Switching the output video resolution on page 25.

7Select the aspect ratio of your TV. Use / to select, then press ENTER.

Setup Navigator

BD PLAYER

Select the screen aspect ratio to match

your TV.

8 Check the settings.	03
Select Proceed, then press ENTER.

Setup Navigator

BD PLAYER

Select [Proceed] if you want to start testing

your audio and video settings.

Proceed

9 Output test tones.

Use / to select Yes, then press ENTER.

Setup Navigator

BD PLAYER

The test tone will be output.

Reduce the volume to an appropriate level.

Yes No

The video and/or audio may not be output under certain setup.

The setup menu comes back in 30 seconds.

Caution

•The screen in step 10 and test tones are output simultaneously according to the settings in steps 4 to 7. Lower the volume of the devices connected with the player.

10 Finish the Setup Navigator menu.

Use / to select Finish, then press ENTER.

Setup Navigator

BD PLAYER

Setup is complete!

Finish Go Back

The setup menu comes back in 30 seconds.

To redo the settings from the start, select Go Back.

Depending on the output terminal setting of step 4 or the HDMI cable being used, it may happen that no picture and/or sound is output. If this happens, the setup returns to step 4 if there is no operation for over 30 seconds. Once the setup returns to step 4, redo the settings according to the connected devices and the HDMI cable being used.

21

En