2 Select and set the method for switching the
07 speaker to be adjusted.
Use / to select, then press ENTER.
•Auto – Switch the speaker to be adjusted automatically.
•Manual – Switch the speaker to be adjusted manually.
3 Adjust the output level.
Use / to select, / to adjust.
| Channel Level |
| BD PLAYER |
L | 0.0 dB |
C | 0.0 dB |
R | 0.0 dB |
SR | 0.0 dB |
SBR | 0.0 dB |
SBL | 0.0 dB |
SL | 0.0 dB |
SW | 0.0 dB |
|
|
Note
•You can also adjust while listening to the sound being played (page 40).
•The volume of the test tones output from the subwoofer may seem lower than the tones output from the other channels. Adjust the subwoofer based on the sound during playback (page 40).
•When Auto is selected, the speaker cannot be selected with /. In this case, test tones are not output from the subwoofer.
Setting the IP address1Select and set Network IP Address Next
Screen.
Use / to select, then press ENTER.
2Set IP address.
Use ///to set the IP address of the player or DNS server, then press ENTER.
Network
BD PLAYER
IP Address |
|
|
Auto Set IP Address | Off | |
IP Address |
|
|
Subnet Mask |
|
|
Default Gateway |
|
|
Auto Set DNS Server Address | Off |
|
DNS Server (Primary) |
|
|
DNS Server (Secondary) |
|
|
•Auto Set IP Address
On – The player’s IP address is obtained automatically. Select this when using a broadband router or broadband modem that has a DHCP (Dynamic Host Configuration Protocol) server function. This player’s IP address will automatically be allocated from the DHCP server.
48
Off – The player’s IP address must be set manually. Use the number buttons (0 to 9) to input the IP address, subnet mask and default gateway.
•Auto Set DNS Server Address
On – The DNS server’s IP address is obtained automatically.
Off – The DNS server’s IP address must be set manually. Use the number buttons (0 to 9) to input the DNS server’s IP address stipulated by your Internet service provider.
Note
•When Auto Set IP Address is set to Off, Auto Set DNS Server Address is also set to Off.
•For information on DHCP server function, refer to the network device’s operating instructions.
•You may need to contact your Internet service
provider or network administrator when inputting the IP address manually.
Setting the proxy serverOnly set the proxy server if so instructed by your Internet service provider.
1Select and set Network Proxy Server Next
Screen.
Use / to select, then press ENTER.
2Select and set Use or Not use at Proxy Server. Use / to change, then press .
Network
BD PLAYER
Proxy Server |
|
|
Proxy Server | Use | |
Server Select Method | Server Name |
|
Server Name |
|
|
Port Number |
|
|
•Use – Select this when using a proxy server.
•Not use – Select this when not using a proxy server. If you have selected Use, proceed to step 3.
3Select and set Server Select Method. Use / to change, then press .
•IP Address – Input the IP address.
•Server Name – Input the server name.
4Input IP Address or Server Name.
Use the number buttons (0 to 9) to input the number if you select IP address by step 3. Use / to move the cursor.
Use the number buttons (0 to 9) to input characters if you select Server Name by step 3.
The characters that can be input for the server name are listed on the table below. Pressing a button repeatedly cycles through the characters shown.
En