Section
04
Installation
Removing the unit
1Extend top and bottom of the trim ring outwards to remove the trim ring. (When reattaching the trim ring, point the side with a groove downwards and attach it.)
Trim ring
!It becomes easy to remove the trim ring if the front panel is released.
2Insert the supplied extraction keys into both sides of the unit until they click into place.
3Pull the unit out of the dashboard.
DIN Rear-mount
1Extend top and bottom of the trim ring outwards to remove the trim ring. (When reattaching the trim ring, point the side with a groove downwards and attach it.)
2Determine the appropriate position where the holes on the bracket and the side of the unit match.
3Tighten two screws on each side.
Screw
Mounting bracket | Dashboard or console |
!Use either truss screws (5 mm × 8 mm) or flush surface screws (5 mm × 9 mm), de-
pending on the shape of screw holes in the bracket.
Fastening the front panel
If you do not plan to detach the front panel, the front panel can be fastened with supplied screw.
Screw
Trim ring
!It becomes easy to remove the trim ring if the front panel is released.
16
En
