Installation
Note:
•Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly.
•Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
•Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
•Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
•The semiconductor laser will be damaged if it overheats, so don’t install the unit anywhere hot — for instance, near a heater outlet.
Removing the unit (Fig. 6) (Fig. 7)
•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 4)
60°
Fig. 4
Frame
Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame.
(When reattaching the frame, point the side with a groove downwards and attach it.)
Fig. 6
<ENGLISH>
DIN | Fixing the front panel | |
| If you do not operate the removing and attaching the front panel function, use the supplied | |
Installation using the screw holes on the side of the unit | fixing screws and holders to fix the front panel to this unit. | |
1. Remove the frame. (Fig. 8) | 1. Attach the holders to both sides of the front panel. (Fig. 11) | |
| ||
Frame |
| |
Insert the release pin into the hole in |
| |
the bottom of the frame and pull out |
| |
to remove the frame. |
| |
(When reattaching the frame, point | Fig. 11 | |
the side with a groove downwards | ||
| ||
and attach it.) | 2. Replace the front panel to the unit. (Fig. 12) |
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN
DIN Front-mount
Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
| Fig. 8 |
2. Fastening the unit to the factory radio mounting bracket. |
|
(Fig. 9) (Fig. 10) |
|
Select a position where the screw holes of the bracket and |
|
the screw holes of the head unit become aligned (are fitted), |
|
and tighten the screws at 2 places on each side. Use either | Fig. 12 |
truss screws (5 ⋅ 8 mm) or flush surface screws | |
(5 ⋅ 9 mm), depending on the shape of the screw holes in |
|
Installation with the rubber bush (Fig. 5)
Dashboard
182
53
Holder
After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Fig. 7
the bracket. | 3. Flip the holders into upright positions. (Fig. 13) |
Fig. 9
Fig. 13
Screw
4. Fix the front panel to the unit using fixing screws. (Fig. 14)
Dashboard or Console
Fixing screw
Factory radio mounting bracket | Fig. 14 |
Fig. 5 | Fig. 10 |
|
