Pioneer DEH-P4770MP installation manual DIN Front/Rear-mount, DIN Front-mount, DIN Rear-mount

Installation <ENGLISH>

INSTALLATION MANUAL

DEH-P4770MP

This product conforms to new cord colors. Los colores de los cables de este producto se conforman con un nuevo código de colores.

As cores dos fios deste produto seguem um novo padrão de cores.

Printed in Thailand
<CRD3952-A/N> CS	<KNNZX> <04J00000>

INSTALLATION			5
		60°
		Fig. 1	Fig. 3
		± qJA	≥ qJA
	1	2	6
		182
MANUAL
	53	3
		4
		Fig. 2	Fig. 4
		≤ qJA	¥ qJA

7	9
	11
	10
Fig. 5	Fig. 7
µ qJA	∑ qJA
8
Fig. 6
∂ qJA

Note:

•Before making a final installation of the unit, temporarily connect the wiring to confirm that the connections are correct and the system works properly.

•Use only the parts included with the unit to ensure proper installation. The use of unautho- rized parts can cause malfunctions.

•Consult with your nearest dealer if installation requires the drilling of holes or other modifica- tions of the vehicle.

•Install the unit where it does not get in the dri- ver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.

•The semiconductor laser will be damaged if it overheats, so don’t install the unit anywhere hot

— for instance, near a heater outlet.

•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 1)

•When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents.

DIN Front/Rear-mount

This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush (Fig. 2)

1.Dashboard

2.Holder

After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them.

(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)

3.Rubber bush

4.Screw

Removing the Unit (Fig. 3) (Fig. 4)

5.Frame

To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)

•It becomes easy to remove the frame if the front panel is released.

6.Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.

DIN Rear-mount

Installation using the screw holes on the side of the unit (Fig. 5) (Fig. 6) (Fig. 7)

1. Remove the frame.

7.Frame

To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)

•It becomes easy to remove the frame if the front panel is released.

2. Fastening the unit to the factory radio mounting bracket.

8.Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the

screws at 2 places on each side. Use either truss screws (5 × 8 mm) or flush surface screws

(5 × 9 mm), depending on the shape of the screw holes in the bracket.

9.Screw

10.Factory radio mounting bracket

11.Dashboard or Console