Pioneer DEH-P510UB Adjusting loudness, Using subwoofer output

+6 to –6is displayed as the level is increased
or decreased.
#You can then select another band and adjust
the level.
5 Press BAND/ESC to cancel the 7-band
graphic equalizer adjustment.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use MULTI-CONTROL to select
Loudness in the audio function menu.
Refer to Introduction of audio adjustments on
page 24.
2 Press MULTI-CONTROL to turn loudness
on.
Loudness level (e.g., Mid) appears in the dis-
play.
#To turn loudness off, press MULTI-CONTROL
again.
3 Push MULTI-CONTROL left or right to
select a desired level.
Each time MULTI-CONTROL is pushed left or
right, level is selected in the following order:
Low (low)—Mid (mid)—High (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1 Press SW/BASS to display the subwoo-
fer setting mode.
Press SW/BASS repeatedly to switch between
the subwoofer setting modes in the following
order.
SubWoofer1 (subwoofer on/off setting) set-
ting mode—SubWoofer2 (subwoofer setting)
setting mode
2 Select SubWoofer1 setting mode.
3 Press MULTI-CONTROL to turn subwoo-
fer output on.
Normal appears in the display. Subwoofer out-
put is now on.
#To turn subwoofer output off, press
MULTI-CONTROL again.
4 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push MULTI-CONTROL left to select reverse
phase and Reverse appears in the display.
Push MULTI-CONTROL right to select normal
phase and Normal appears in the display.
Note
You can also switch to this setting mode in the
menu that appears by using MULTI-CONTROL.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
!When the subwoofer output is on, you can
select SubWoofer2.
1 Press SW/BASS to display the subwoo-
fer setting mode.
Press SW/BASS repeatedly to switch between
the subwoofer setting modes in the following
order.
SubWoofer1 (subwoofer on/off setting) set-
ting mode—SubWoofer2 (subwoofer setting)
setting mode
2 Select SubWoofer2 setting mode.
3 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50Hz—63Hz—80Hz—100Hz—125Hz
Audio Adjustments
En
26
Section
03