Setting the rear output and

subwoofer controller

This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Rear SP :F.Range) or subwoo-
fer (Rear SP :S/W) connection. If you switch
the rear output setting to Rear SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (Rear SP :F.Range).
1 Use MULTI-CONTROL to select
S/W control in the initial setting menu.
Refer to Adjusting initial settings on page 28.
2 Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will switch be-
tween Rear SP :F.Range (full-range speaker)
and Rear SP :S/W (subwoofer) and that status
will be displayed.
#When no subwoofer is connected to the rear
output, select Rear SP :F.Range (full-range speak-
er).
#When a subwoofer is connected to the rear
output, select Rear SP :S/W (subwoofer).
Notes
!Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
26).
!If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
!Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.

Switching the sound

muting/attenuation

Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
!The sound is muted or attenuated, MUTE
or ATT are displayed and no audio adjust-
ment is possible.
!Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Use MULTI-CONTROL to select Mute in
the initial setting menu.
Refer to Adjusting initial settings on page 28.
2 Press MULTI-CONTROL to switch the tel-
ephone muting/attenuation.
Pressing MULTI-CONTROL will switch be-
tween TEL ATT (attenuation) and TEL mute
(muting) and that status will be displayed.

Setting the internal power

amplifier

This unit features high power amplifier. How-
ever, in particular system, external amplifiers
are used instead of internal amplifier. If you
use external amplifiers in order to establish a
multi-amp system, and don’t use internal am-
plifier, it is recommended to turn off the inter-
nal amplifier. Turning off internal amplifier
reduces the noise that comes from the beha-
vior of internal amplifier.
1 Display the initial setting menu.
2 Use MULTI-CONTROL to select
Built-in AMP in the initial setting menu.
Refer to Adjusting initial settings on page 28.
3 Press MULTI-CONTROL to turn the inter-
nal power amplifier on.
#To turn the internal power amplifier off, press
MULTI-CONTROL again.
Initial Settings
En
30
Section
04