ENGLISH
DIN | Fastening the front panel |
1.Extend top and bottom of the trim ring outwards to remove the trim ring. When reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the trim ring is attached upside down, the trim ring will not fit properly.)
•It becomes easy to remove the trim ring if the front panel is released.
If you do not plan to detach the front panel, the front panel can be fastened with supplied screws and holders.
1. Attach the holders to both sides of the front panel.
Trim ring
Holder
2.Determine the appropriate position where the holes on the bracket and the side of the unit match.
3.Tighten two screws on each side.
•Use either truss screws (5 mm ⋅ 8 mm) or flush surface screws (5 mm ⋅ 9 mm), depend- ing on the shape of screw holes in the bracket.
Screw
Dashboard or Console
Factory radio mounting bracket
2. Replace the front panel to the unit.
3. Flip the holders into upright positions.
4.Fix the front panel to the unit using screws.
Screw
