Pioneer DJ Controller Serato DJ Edition Using the LAPTOP DOCK, Using with the feet removed, Microphone/External input control section, SHIFT, SHIFT, Press:, MASTER, (p.21), (p.21), 2LEVEL control

1FX CH SELECT controlSwitches the channel to which the effect is applied.

!Effects applied to the MIC/AUX channel cannot be used with Serato DJ ver. 1.2. They are scheduled to be supported with future version upgrades.

2EFFECT SELECT controlSelects the type of effect.3BEATS (PARAMETER) controlAdjusts the effect time.[SHIFT] + turn:Adjusts the effect’s parameter 3.4LEVEL/DEPTH control

Adjusts the effect’s parameter 1.

5FX ON/OFF buttonTurns the effect on/off.6TAP/AUTO (FX MODE) button

Press:

The BPM used as the base value for the effect is calculated by the interval at which the button is tapped with a finger.

When the button is pressed and held, the effect time is reset.

[SHIFT] + press:

Switches the effect mode from the single mode to the multi mode. When the [SHIFT] and [TAP/AUTO (FX MODE)] buttons are pressed again, the effect mode returns to the single mode.

To monitor the effect sounds

When the [HEADPHONES MIXING] control is turned to the [CUE] side, the Serato DJ software’s effect sounds are not output to the sound of the channels whose headphones [CUE] button are pressed. If you want to monitor the Serato DJ software’s effect sounds, turn the

[HEADPHONES MIXING] control to the [MASTER] side and monitor the effect sounds in the sound of the master output.

Using the LAPTOP DOCK

The computer’s keyboard section can be stowed under this unit.

!Depending on the size of your (notebook) computer, the keyboard section may not fit in the LAPTOP DOCK.

!Install in such a way that the computer unit does not touch this unit.

!Install in such a way that the cables connected to the computer are not stuck under this unit.

Using with the feet removed

This unit’s two feet can be removed.

Use a Phillips screwdriver to remove the screws from the left and right feet (2 screws each).

!The screws you have removed will be needed when mounting the feet. Be careful not to lose them. The feet cannot be properly mounted using other screws.

names part and Connections

Microphone/External input control section

	MIC1							EQ
			LEVEL		LOW			MID	HI
		TALK
	OFF	ON OVER
MIC1			MIN	MAX	MIN	MAX	MIN	MAX MIN	MAX
	1		2		3				4
MIC2 / AUX					EQ
	LEVEL		LOW		MID		HI	INPUT
	TALK
OFF ON								SELECT
	OVER							MIC 2	AUX
	MIN	MAX	MIN	MAX MIN	MAX	MIN		MAX

1OFF, ON, MIC TALK OVER selector switchTurns the microphone on/off.

=Using a microphone (p.21)

2LEVEL controlAdjusts the level of the output sound.3EQ (HI, MID, LOW) controlsBoosts or cuts frequencies in order to change the quality of the sound.4MIC2/AUX selector switchSwitches the audio input between the microphone and the external device.![MIC2]: Selects the microphone connected to the [MIC2] terminal.![AUX]: Selects the external device connected to the [AUX IN] terminals.

=Using a microphone (p.21)

=Using an external device (p.21)

En 13