Pioneer DJM-800 Connecting Microphone and Headphones, Connecting the Power Cord

S002_En

CONNECTIONS (CONNECTING MICROPHONE AND HEADPHONES/CONNECTING THE POWER CORD)

CONNECTING MICROPHONE AND HEADPHONES

Microphone

The MIC 1 jack on the upper surface of the operating panel can be used to connect a microphone with Ø6.3 mm phone plug or XLR plug.

The MIC 2 jack on the upper surface of the operating panel can be used to connect a microphone with Ø6.3 mm phone plugs.

¶When the connection panel’s MIC SIGNAL switch is set to [CUT], no microphone sounds will be output from the BOOTH monitor output connectors.

Microphone 1

(Microphone 1)

MIC

MIC 1 MIC 2

	MIC 1
	LEVEL
	0
	MIC 2
Microphone 2	LEVEL
	0
	HI
-12	+6

EQ

LOW

-12 +6

Headphones

The PHONES jack on the upper surface of the operating panel can be used to connect headphones with a Ø6.3 mm stereo phone plug.

HEADPHONES

MONO SPLIT STEREO

MIXING

CUE MASTER

LEVEL

0

PHONES

Headphones

English

MIC

OFF ON TALK

OVER

CONNECTING THE POWER CORD

Connect the power cord last.

÷After completing all other connections, connect the accessory power cord to the AC inlet on the back of the player, then connect the plug to a standard wall outlet or to the auxiliary power outlet of your amplifier.

÷Use only the supplied power cord.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement.

7

<DRB1394> En