Pioneer DV-270-S, DV-373-K Setting the TV system, Resetting the player, Power reset, Auto, Ntsc

08Additional information

Note

•Using the 16:9 (Wide) setting with a standard 4:3 TV, or either of the 4:3 settings with a widescreen TV, will result in a distorted picture.

Setting the TV system

(Except DV-270-s and DV-373-s Taiwanese model)

The default setting of this player is AUTO, and unless you notice that the picture is distorted when playing some discs, you should leave it set to AUTO. If you experience picture distor- tion with some discs, set the TV system to match your country or region’s system. Doing this, however, may restrict the kinds of disc you can watch. The table below shows what kinds of disc are compatible with each setting (AUTO, PAL and NTSC).

1 If the player is on, press STANDBY/ ON to switch it to standby.

2 Using the front panel controls, hold

down then press STANDBY/ON to switch the TV system.

The TV system changes as follows:

• AUTO	NTSC
• NTSC	PAL
• PAL	AUTO

Note

•You have to switch the player into standby (press STANDBY/ON) before each change.

Disc		Player setting
Type	Format	NTSC	PAL	AUTO
DVD/	NTSC	NTSC	PAL	NTSC
Super	PAL	NTSC	PAL	PAL
VCD
Video CD	NTSC	NTSC	PAL	NTSC
	PAL	NTSC	PAL	PAL
CD	—	NTSC	PAL	NTSC or
no disc				PAL

Resetting the player

Use this procedure to reset all the player’s settings to the factory default.

1Switch the player into standby.

2Using the front panel buttons,

hold down the (stop) button and press STANDBY/ON to switch the player back

on.

All the player’s settings are now reset.

Power reset

Use this procedure to switch the power off if the player is unresponsive to any control from the front panel or remote.

1Press and hold the front panel STANDBY/ON for 10 seconds.

When the power is completely off, you cannot use the remote to switch it back on again. Use the front panel STANDBY/ON button.

36

En