Basic connections | Before making or changing any rear panel connections, make sure that |
all components are switched off and unplugged from the wall outlet. |
Antenna to DVD/VCR connection
The DVD/VCR must be connected “between” the antenna and the TV. First, disconnect the antenna from the TV and connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an antenna sys- tem to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram.
Example 1: Combination VHF/UHF antenna with 75 ohm coaxial cable
75 ohm coaxial | |
| |
cable |
|
| DVD/VCR |
Example 2: Combination VHF/UHF antenna with 300 ohm twin lead (flat) wire
| Matching transformer | |
| 300 ohm input 75 ohm | |
| output (not supplied) | |
| 300 ohm twin lead | |
| ||
| (flat) wire | |
|
| DVD/VCR |
Example 3: Separate VHF and UHF antennas | ||
| Combiner |
|
| 75/300 ohm inputs |
|
| 75 ohm output (not supplied) | |
VHF | UHF | |
| lead (flat) wire | |
| 300 ohm twin |
|
| 75 ohm coaxial | DVD/VCR |
| cable | |
NOTE:
If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm inputs and one 75 ohm output.
NOTES:
•A clear picture will not be obtained by the main unit unless the antenna signal is good. Connect the antenna to the main unit properly.
•For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an outdoor type antenna is required.
•If you are not sure about the connection, please refer to qualified service personnel.
DVD/VCR to TV connection
After you have connected the antenna to the DVD/VCR, you must connect the DVD/VCR to the TV.
Below are 3 common methods of connecting your DVD/VCR to a TV. Find the type of TV you are using and follow the con- nection diagram.
This DVD/VCR has a single 75 ohm output for connection to a TV.If your TV has separate VHF and UHF antenna inputs (num- bers 2 and 3 below), use a splitter to connect the DVD/VCR to the TV for VHF and UHF reception.
Example 1: TV with single 75 ohm VHF/UHF antenna input
| 75 ohm coaxial | TV | |
|
| ||
| cable (supplied) | ||
| DVD/VCR |
|
|
Example 2: TV with 300 ohm UHF and 75 ohm VHF | |||
| antenna inputs |
| |
(supplied) |
| TV | |
| |||
75 ohm coaxial cable |
| ||
|
|
| |
DVD/VCR |
| Splitter 75 ohm input | |
|
| 75/300 ohm outputs | |
|
| (not supplied) |
|
Example 3: TV with 300 ohm UHF and 300 ohm VHF
| antenna inputs | TV |
| ||
(supplied) | ||
75 ohm coaxial cable |
| |
|
| |
DVD/VCR |
| Splitter 75 ohm input |
|
| 300 ohm output |
|
| (not supplied) |
NOTE:
If a VHF or UHF antenna is used, set the TV/CABLE menu option to the “TV” mode.
10
