A HARDWARE TOUR

TOP VIEW

0

0 Function switch
ON OFF

This switch is used to check the device before shipment, and its setting should never be changed.

Set OFF at the time of shipping from the plant.

TO INSTALL THE DRIVE

For instructions on how to open the access doors, see the operating instructions for the DRM-7000 disc changer.

Before installation, be sure to specify the following settings at the rear of each drive to be installed.

SCSI ID assignment

Specify the SCSI IDs to be used so as to ensure that the same SCSI ID is not assigned by more than one drive on the same SCSI bus.

Termination

Set the termination switch of the last drive in the SCSI chain to the ON position.

1.When inserting a drive, be sure to place the drive on the changer guide rails and push the drive in until the lock lever on the drive shifts to the locked position. Maybe you can hear a clicking sound then.

Guide rails

Drive

Warning about static electricity
Always be sure never to touch the contacts or ports when operating drives.

Also be sure to touch a metallic surface on the changer before installing additional drives to the changer.

Lock lever

When a drive is to be removed from the changer, flip the lock lever to the released position and then pull the drive out from the changer.

8

En