TO INSTALL THE DRIVE

2.Connect the power cable.

When the power cable has been connected, the wiring monitor indicator on the rear of the drives (orange) will light up.

When the termination switch of the drive is set to on, the termination indicator (green) will light up.

Power cable

Wiring monitor indicator Termination indicator

3.Connect the changer interface cable.

When the changer interface cable has been connected, the wiring monitor indicators will flash at two-second intervals.

Wiring monitor indicator

Changer interface cable

NOTE:

Connect the changer interface cable to the connector corresponding to the bay in which the drives have been installed. (Note that labels are affixed to connectors indicating the corresponding bay number.) Note that it is extremely important to do this, as connecting the changer interface cable to a neighboring bay will result in damage to discs and the disc transport mechanism.

English

4. Connect SCSI cables.

The way in which SCSI cables should be connected differs depending on how the changer is to be configured. For further information on how to connect SCSI cables, see the operating instructions for the DRM- 7000 disc changer.

ABOUT REGION CODES

Region codes are part of the DVD standard. There is a Region number located within one or all of the components required for DVD-VIDEO playback.

The region code on the DVD-R7322 can be changed ONLY 5 times, including the 1st setting. Please be aware that the 5th change will be PERMANENT. Therefore please use caution when changing the region code.

NOTE:

The method of changing the Region number will vary depending on the Decoder/ Operating System used.

9

En