A HARDWARE TOUR

REAR VIEW

1 2 34

5

 

 

6

7

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1

2

3

4

 

ON

 

 

4

WIRING

 

 

 

 

MONITOR IND

 

 

 

3

SCSI TERM IND

 

 

 

2

PARITY ON / OFF

1 TERM ON / OFF

RELEASE LOCK

SCSI ID

English

8

1 SCSI termination switch

This switch is used to turn the drive's internal SCSI termination switch on and off. Note that this switch is set on at the time of shipment.

2 Parity Switch

Use to set SCSI parity check function ON/ OFF. Note that this switch is set on at the time of shipment.

3 Termination indicator

When the drive is installed in a changer and its power cable has been connected, this indicator lights up if the drive's SCSI termination switch has been turned on.

4 Wiring monitor indicatorMeaning of indicator when indicator is lit up:Indicates that a disc has been inserted into the drive.

This indicator also lights up when the drive is installed in a changer and its power cable has been connected.

Meaning of indicator when indicator flashes in 2-second intervals:

This indicator flashes in 2-second intervals when the drive is installed in a changer and its changer interface cable has been connected.

Meaning of indicator when indicator flashes in 0.5-second intervals:

This indicator flashes in 0.5-second intervals

9

when the drive in question has been specified as the drive to be swapped during the swapping of drives.

5 Changer interface cable

This cable must be connected to the changer interface connector located in the changer.

6 Power cableThis cable must be connected to the power inlet located in the changer.7 Lock lever

When a drive is to be removed from the changer, flip the lock lever to the released position and then pull the drive out from the changer.

8 SCSI ID switch

Use to set the SCSI ID. Press the protruding tab at left to increment numbers, and press the tab at right to decrement numbers. Factory default setting is "0".

9 SCSI interface connector

This connector must be connected to the SCSI cable provided with the changer or to an add-on SCSI cable.

NOTE:

Be careful not to allow any part of your body to come into contact with connector pins, as doing so may result in faulty connections or damage from static electricity.

7

En