Pioneer DVR-310 operating instructions Message

Additional information 13

On-screen displays and recorder displays

The table below shows a list of error messages that you may encounter when using the recorder and an explanation of their meaning.

Message Explanation/Action

•Initializing disc. Please wait a moment. When you load a blank DVD-RW disc, the recorder automatically

initializes it.

• Incompatible region number.	The disc loaded has an incompatible region number for the
	recorder and so will not play.
• Cannot record any more titles.	The disc control data limit has been reached, or the maximum

•No more space for file management data. number of chapters and/or titles has been reached. Erase titles/

• Cannot add any more chapter marks. chapters or combine chapters.

•This disc cannot be recorded. Undo the final- The disc was finalized on a non-Pioneer DVD recorder. Undo the

ization.	finalization in order to recording/editing.
• Cannot play this disc.	The disc may be dirty or damaged. Take out the disc, clean it and
• This disc cannot be recorded.	retry. If the error persists, use a new disc. If the error appears even

•Cannot read the CPRM information.with a new disc, please consult a Pioneer Service Center.

•Could not record the information to the disc.

•Cannot edit.

•Could not initialize disc.

•Could not complete finalization successfully.

•Could not undo finalization successfully.

•Could not successfully unlock the disc.

•Cannot record to a disc that is not CPRM com- patible.

•Cannot record this content using Video mode recording.

The video source is copy-once protected. Use a VR mode DVD-RW disc with CPRM for recording.

• This content is copy protected.	The video source is copy-protected and cannot be recorded.
• Incorrect CPRM information.	The recorder could not read the CPRM information. The recorder
	may be damaged—please consult a Pioneer Service Center.
• No DV input.	No signal was detected at the DV input/output jack. This may

•Cannot preview because there is no DV input. appear if a blank section of DV tape is playing in the connected

camcorder.

•The audio will conform to the [Dual Mono Recording] setting.

When recording from an external input in Video mode, or in VR mode set to MN 32, audio is recorded in Linear PCM format. You can only record the left or right channel; not both.

• Repairing disc.	During recording, the power was cut. This display appears when
	the power is restored.

• Could not repair the disc.

The recorder was unable to repair the disc after a power cut. The contents of the recording will be lost.

•Overheating has stopped operation. Press DISPLAY to clear this message.

The internal temperature of the recorder has exceeded the operating limit. If this message reappears, please contact a Pioneer authorized service center.

91

En