08
Section
En
36
Initial Settings
Switching the rear output setting
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer output
on (refer to Using subwoofer output on page 32).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this set-
ting.
1 Press FUNCTION to select the rear output
setting mode.
Press FUNCTION repeatedly until FRT+REAR
appears in the display.
• If the rear output setting has been set to the
subwoofer then FRT+S/W will be displayed.
2 Select full-range speaker or subwoofer
with 2/3.
Pressing 2/3will switch between FRT+REAR
(full-range speaker) and FRT+S/W (subwoofer)
and that status will be displayed.