Pioneer PD-F907 specifications To remove the discs, Disc

HOW TO LOAD THE DISCS (Be sure to read this before operation)

Loading discs into the rack

ÖYou can load up to 100 discs in the rack.

The numbers marked on the rack are used as the disc numbers. These are marked in the clockwise order from 1 to 100.

ÖThe following procedure describes how to load discs from disc No. 1.

Notes!!

ÖDo not attempt to open the hood with your hand.

ÖBe careful not to pinch your fingers when opening and closing the hood.

ÖIf a disc is inserted with its label side facing to the right, it cannot be played back. Be sure to load all discs with their label sides facing to the left.

1	POWER	Press POWER STANDBY/
	STANDBY / ON	ON switch.
		Ö Ensure that the disc No.
		shown on the display is “1”.
		Ö If the displayed disc No. is
		not “1”, press DISC(–/+)
		to display “1”.
2	UNLOAD	Press UNLOAD.

Ç

WARNING:

Do not put your hand or any other object inside the rack, otherwise injury or part damage may result.

D

DISC TRACK MIN SEC

D

3

D

ALL

The hood will open.

When UNLOAD is pressed, the hood opens to the disc corresponding to the disc No. displayed on the front of the unit. Therefore, if you want to load discs from No. 50, use DISC (–/+)on the unit to dis- play “50”, or enter “50” using the remote control unit, before pressing UNLOAD.

Load the disc into the rack with the label side (printed surface) facing to the left.

Side to be played faces right (label side faces left)

Ö Do not put anything other than CDs inside the rack.
Ö Do not use adapters for 8-cm (3-in.) CDs.
Ö Load only one disc into each disc slot.
Ö Inserting an 8-cm (3-in.) CDs in between two 12-cm (5-in.) CDs,
will make it difficult to remove the 8-cm (3-in.) CD.
We recommend inserting 12-cm (5-in.) CDs starting from Disc No.
1 (i.e., 1, 2, 3...) and 8-cm (3-in.) CDs starting from Disc No. 100
(i.e., 100, 99, 98...).
	OPERATING	BEFORE
Ö The unit will not operate if the hood is opened during playback. Be
sure to close the hood before attempting any operations.
Ö To load or remove a disc in or from the slot which is seen through
the hood, press OPEN/CLOSE. The hood is opened, “HOLD” is
displayed and the disc can be loaded in or ejected from the slot
seen through the hood. Even while “HOLD” is being displayed,
the rack can be rotated by pressing DISC (–/+).
	OPERATIONS	BASIC
Ö Be sure to remove all discs from the rack, set the POWER
STANDBY/ON switch to off, and unplug the power cord before
moving the unit.

4	DISC	Press DISC(+) to rotate
		the rack.
		Ö The rack rotates in the di-
		rection of 1,2,3.... Press-
		ing DISC(–)rotates the
		rack in the opposite direc-
		tion.

5 Load other discs into the rack by repeating steps 3 and 4 for each of them.

6 OPEN/Press OPEN/CLOSE.

CLOSE Ö The hood will close.

Tip:

Difference between OPEN/CLOSE and UNLOAD OPEN/CLOSE: The hood is simply opened or closed. UNLOAD:The slot corresponding to the disc No. being displayed rotates to the center position then the hood is opened.

To remove the discs...

1	Press UNLOAD.	VARIOUS OPERATIONS
2	Ö The hood will close.
	Select the disc No. to be removed by pressing DISC(–/+).
	Ö The rack rotates until the selected disc comes in the front of
	the unit.
3	Remove from the rack.
4	Press OPEN/CLOSE.

9

<PRB1268> En