CAUTIONS REGARDING HANDLING

Location

Install the player in a well-ventilated location where it will not be exposed to high temperatures or humidity.

Do not install the player in a location which is exposed to direct rays of the sun, or near stoves or radiators. Excessive heat can adversely affect the cabinet and internal components. Installation of the player in a damp or dusty environment may also result in a malfunction or an accident. (Avoid installation near cookers etc., where the player may be exposed to oily smoke, steam or heat.)

Do not install the player on a tottered stand nor in an unstable or inclined place.

Condensation

When this unit is brought into a warm room from previously cold surroundings or when the room temperature rises sharply, con- densation may form inside, and the unit may not be able to attain its full performance. If this occurs, allow the unit to stand for about an hour or raise the room temperature gradually.

Precautions regarding installation

ÖPlacing and using the compact disc player for long periods on heat-generating sources such as amplifiers will affect perfor- mance. Avoid placing the player on heat-generating sources.

ÖInstall this compact disc player as far as possible from tuners and TV sets. A compact disc player installed in close proximity to such equipment may cause noise or degradation of the pic- ture.

ÖSuch noise may be particularly noticeable when an indoor an- tenna is used. In such cases, make use of an outdoor antenna, or turn off power to the compact disc player.

ÖPlease place this unit on a level surface.

Cleaning the player

To clean the PLAYER, wipe with a soft, dry cloth. For stubborn dirt, wet a soft cloth with a mild detergent solution made by dilut- ing one part detergent to 5 or 6 parts water, wring well, then wipe off the dirt. Also use a dry cloth to wipe the surface dry. Do not use volatile liquids such as benzene and thinner which are harmful to the unit.

Storing discs

ÖDiscs are made of the same kinds of plastic used for conven- tional analog audio records. Be careful not to allow discs to warp; always store discs in their cases vertically, avoiding loca- tions with high heat or humidity, or extremely low tempera- tures. Avoid leaving discs in cars, since the seat of a car in direct sunlight can become unbelievably hot.

ÖAlways read and abide by the precautionary notes listed on disc

labels.

CD lens cleaner

The player's pickup lens should not become dirty in normal use, but if for some reason it should malfunction due to soiling, consult your nearest PIONEER authorized service center. Lens cleaners for CD players are commercially available, but special care should be exer- cised in their use since some may cause damage to the lens.

Cleaning and handling compact discs

Ö The presence of fingerprints or smudges on the surface of the disc will not directly affect the recorded signals, but depending on the degree of contamination, the brightness of the light reflected from the signal surfaces may be reduced, causing degradation of sound quality. Always keep your discs clean by wiping them gently with a soft cloth from the inner edge to- ward the outer periphery.

Ö If a disc becomes very dirty, dip a soft cloth in water, and after wringing it out well, wipe the dirt away gently, and then remove any water drops with another soft, dry cloth.

Ö Do not use record cleaning sprays or anti-static agents on discs. Also, never clean discs with benzene, thinner, or other volatile

solvents, since damage to the disc surface may result.

OPERATING

BEFORE

Record

 

 

 

cleaning

 

 

 

 

 

sprays

Thinner

Benzene

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OPERATIONS

BASIC

With this unit, use a Compact Disc carrying the mark shown

 

 

 

 

below. Do not use other disc, for this may result in malfunction

 

 

 

or damage.

 

 

 

 

 

 

 

 

 

Ö When holding discs, do not touch their signal surfaces. Hold by

 

 

the edges, or by one edge and the center hole.

 

 

Ö Do not affix gummed labels or tape to the label surfaces. Also,

 

 

 

 

do not scratch or damage the label.

 

 

Ö Discs rotate at high speed inside the player. Do not use dam-

 

 

aged (cracked or warped) discs.

 

 

 

 

Ö Do not play a CD with a special shape (having other shape than

OPERATIONS

VARIOUS

a circular disc, such as a heart shaped disc). Otherwise mal-

 

 

function may occur.

'

Re-transporting

When re-transporting this unit in the future, remove all discs from the rack. Turn off the STANDBY/ON switch, wait for "OFF" to go out from the display, and unplug the power cord.

5

<PRB1268> En

Page 5
Image 5
Pioneer PD-F907 specifications Solvents, since damage to the disc surface may result, Function may occur