![6. Tighten from below using the](/images/new-backgrounds/29943/2994315x1.webp)
English
6. Tighten from below using the | SPECIFICATIONS |
|
|
supplied screws (three locations). | Cabinet | ||
| |||
• Tighten the three screws in order ➀, ➁, ➂ as shown in | Used speaker |
|
|
the diagram (see page 7). | Woofer (for low tones) | 4.8 cm ⋅ 13 cm cone type | |
The screw hole at the rear surface of the speaker bracket | Tweeter (for high tones) | 2.5 cm semidome type | |
is used when the flat screen TV is installed with the table | Impedance | 6 Ω | |
top stand. It is not used when installed on the wall. | Frequency Range | 55 Hz to 30 000 Hz | |
NOTE: | Sensitivity (1 m, 1 W) | 80 dB | |
Permissible input : |
|
| |
If after attaching the speaker its position needs to be | Max. input | 18 W | |
adjusted horizontally, first loosen the speaker mounting | Rated input | 6 W | |
screws, reposition and then tighten the screws again at the | Crossover frequency | 3 kHz | |
appropriate position. | External Dimensions |
|
|
| ..............................1 465 (W) mm ⋅ 78 (H) mm ⋅ 93 (D) mm | ||
7. Bundling the cables (See procedure 7 | Weight : |
|
|
Speaker only | 3.15 kg | ||
on page 6). | With cables, brackets and screws | .............................. 3.7 kg | |
| Accessory parts |
|
|
CABINET MAINTENANCE | ................................................................. | Speaker Cables ⋅ 2 | |
.................................................................... | Speaker Brackets | ||
• Use a polishing cloth or dry cloth to wipe off dust and dirt. |
|
| Left ⋅ 1 |
|
| Right ⋅ 1 | |
• When the cabinet is very dirty, wipe with a soft cloth |
|
| |
|
| Center ⋅ 1 | |
moistened with | ...................... Speaker Mounting Screws (M5 ⋅ 10 mm) ⋅ 9 | ||
with a dry cloth. Do not use furniture wax or cleaners. | ..................................................... | Operating Instructions ⋅ 1 | |
They may damage the surface of the cabinet. |
|
|
|
• Never use thinner, benzine, insecticide sprays and other | NOTE: | |
chemicals on or near the cabinets, since these will | ||
Specifications and design subject to possible modification | ||
corrode the surfaces. | ||
without notice, due to improvements. | ||
• When a chemical cloth is used, read the cautions for the | ||
| ||
chemical cloth carefully. |
|
��������������������������������������������������������������������������������������������������������������������������������
����������������������������������������������������������������������������������������������������������
�����������������������������������������������������������������������������������������������������������������������������������������
��������������������������������������������������������������������������������������
������������������������������������������������������������������������������������������������������������
��������������������������������������������������������������������������������������������������������������������������������������������
����������������������������������������������������� | ��������� |
Published by Pioneer Corporation.
Copyright © 2008 Pioneer Corporation.
All rights reserved.
8