Safety Switch
NOTE: The magnetic switch is there for your safety and should not be replaced by a standard power switch. If the power goes out, the magnetic switch prevents the machine from starting when the power is returned, and protects the operator from an accidental start and possible injury.
Figure 9
Gearbox Oil Level
!
WARNING: Before starting your machine for the first time, make sure the gearbox has oil. The proper oil level is just even with the bottom of the fill plug hole. The gearbox uses
To check the gearbox oil level:
1Remove the gearbox fill plug (Figure 11).
2Using the short end of the hex wrench, dip it inside the fill hole and remove it. If the end of the hex wrench is coated with oil, then the gearbox oil level is okay.
3Replace the fill plug and skip to the next section. If the end of the hex wrench is not coated with oil, then you need to add more oil. Refer to main-
tenance section of this manual for instructions on how add or drain oil.
NOTE: Replace the gearbox oil after the first 20 hours of operation. This is a normal
Figure 10
Fill Plug
Drain
Figure 11
14 | © 2006 Pioneer Supply International |
