Pioneer SRC7127-B/N Adjusting loudness, Using subwoofer output, Fine-adjustingequalizer curve

	Section
Operating this unit	02

Fine-adjusting equalizer curve

You can adjust the center frequency and the Q factor (curve characteristics) of each currently selected curve band (EQ-LOW/EQ-MID/ EQ-HIGH).

Level (dB)

Q=2N Q=2W

Center frequency Frequency (Hz)

1Press AUDIO and hold until frequency and the Q factor (e.g., F-80 Q-1W) appears in the display.

2Press AUDIO to select the band for ad- justment from among low, mid and high.

3Press c or d to select the desired fre- quency.

Low: 40—80—100—160 (Hz)

Mid: 200—500—1k—2k (Hz)

High: 3k—8k—10k—12k (Hz)

4Press a or b to select the desired Q fac-

tor.

2W—1W—1N—2N

Note

If you make adjustments, CUSTOM curve is up- dated.

Adjusting loudness

Loudness compensates for deficiencies in the low- and high-sound ranges at low volume.

1Press AUDIO to select LOUDNESS.

2Press a to turn loudness on. Loudness level (e.g., LOUDNESS MID) ap-

pears in the display.

# To turn loudness off, press b.

3Press c or d to select a desired level. LOW (low)—MID (mid)—HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output which can be turned on or off.

1 Press SW to select SUBWOOFER.

#You can also select the subwoofer setting menu by pressing AUDIO on the unit.

2Press a to turn subwoofer output on. SUBWOOFER NOR appears in the display.

Subwoofer output is now on.

# If the subwoofer output phase has been set to

the reverse, SUBWOOFER REV will be displayed.

# To turn subwoofer output off, press b.

3Press c or d to select the phase of sub- woofer output.

Press c to select reverse phase and REV ap- pears in the display. Press d to select normal phase and NOR appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad- just the cut-off frequency and the output level of the subwoofer.

1 Press SW to select SUBWOOFER.

#You can also select the subwoofer setting menu by pressing AUDIO on the unit.

#When the subwoofer output is on, you can se- lect SUBWOOFER (subwoofer setting).

2Press c or d to select cut-off frequency. 50—63—80—100—125 (Hz)

Only frequencies lower than those in the se- lected range are outputted from the subwoo- fer.

3Press a or b to adjust the output level of the subwoofer.

+6 to –24 is displayed as the level is increased or decreased.

English

En 19