Pioneer SRC7127-B/N Using the high pass filter, Boosting the bass, Front image enhancer F.I.E

Section

02Operating this unit

Using the high pass filter

When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are outputted from the front or rear speakers.

1Press AUDIO to select HP-FILTER.

2Press a to turn high pass filter on. HP-FILTER 80 appears in the display. High

pass filter is now on.

# If the high pass filter has been previously ad- justed, the frequency of that previously selected

will be displayed instead of HP-FILTER 80.

# To turn high pass filter off, press b.

3Press c or d to select cut-off frequency. 50—63—80—100—125 (Hz)

Only frequencies higher than those in the se- lected range are outputted from the front or rear speakers.

Boosting the bass

Bass boost function boosts the bass level of sound lower than 100 Hz. The more the bass level is increased, the more the bass sound is emphasized and the entire sound becomes powerful. When using this function with the subwoofer, the sound under the cut-off fre- quency is boosted.

1Press AUDIO to select BASSBOOSTER.

# You can also select the bass boost setting by pressing and holding SW.

2Press a or b to select a desired level.

0 to +6 is displayed as the level is increased or decreased.

Front image enhancer (F.I.E.)

The F.I.E. (Front Image Enhancer) function is a simple method of enhancing front imaging by cutting mid- and high-range frequency output from the rear speakers, limiting their output to

low-range frequencies. You can select the fre- quency you want to cut.

Precaution

When the F.I.E. function is deactivated, the rear speakers output sound of all frequencies, not just bass sounds. Reduce the volume before disenga- ging F.I.E. to prevent a sudden increase in vo- lume.

1 Press AUDIO to select FIE.

#When the rear output setting is REAR SP S/W, you cannot select FIE.

2Press a to turn F.I.E. on.

# To turn F.I.E. off, press b.

3Press c or d to select a desired fre- quency.

100—160—250 (Hz)

Notes

!After turning the F.I.E. function on, use the bal- ance adjustment (refer to page 18) and adjust front and rear speaker volume levels until they are balanced.

!Turn the F.I.E. function off when using a 2- speaker system.

Adjusting source levels

SLA (source level adjustment) lets you adjust the volume level of each source to prevent ra- dical changes in volume when switching be- tween sources.

!Settings are based on the FM tuner volume level, which remains unchanged.

1Compare the FM tuner volume level with the level of the source you wish to ad- just.

2Press AUDIO to select SLA.

20 En