Pioneer HTP-330, SX-SW330 S L P, 09Additional information Chapter, Setting the sleep timer

09Additional information

Chapter 9

Additional information

Setting the sleep timer

The sleep timer switches off the receiver subwoofer after a specified time so you can fall asleep without worrying

about it.1

	SLEEP
ENTER	CLEAR
SETUP	SR
	TUNE
ST	ST
	ENTER
SOUND	TEST
	TONE

1Press the SLEEP button to select an option. Choose between the following options:

•SLP ON – Switches off after about an hour

•SLP OFF – Cancels the sleep timer

After selecting SLP ON, you can press SLEEP again to check how much time is left. Each line indicates approximately 12 minutes (remaining):

S L P - - - - -

Dimming the display

You can choose to dim the display if you find it too bright.2

	SLEEP
ENTER	CLEAR
SETUP	SR
	TUNE
ST	ST
	ENTER
SOUND	TEST
	TONE
	TUNE
SOUND
RETRIEVER

1 Press SETUP.

DTS CD setting

If you play a DTS-encoded CD, you will need to change this setting to hear the decoded signal.

1Switch the system into standby.

2Press SETUP.

3	Use the	(cursor left/right) buttons to select
CD TYPE from the menu, then press ENTER.
4	Use the	(cursor up/down) buttons to select a

setting, then press ENTER. Select from:

•NORMAL – Use for playback of regular audio CDs. Some DTS-encoded CDs will output noise when played.

•DTS-CD– Use for playback of DTS-encoded CDs, but note that the beginning of regular CD tracks may be skipped.

Resetting the system

Use this procedure to reset all system settings to the factory default.

1Switch the system on.

2Press and hold SURROUND then press the

STANDBY/ON button on the display unit. The next time you switch on, all the system settings should be reset.

2	Use the	(cursor left/right) buttons to select
DIMMER then press ENTER.
3	Use the	(cursor up/down) buttons to select

LIGHT or DARK then press ENTER.

Note

1The display dims when the sleep timer is set.

2The display dims when the sleep timer is set, regardless of this setting.

26

En