Other connections | 08 |
Tip
•You can select channels directly by pressing D.ACCESS, then the
•You can press DISPLAY to change SIRIUS Radio information in the front panel display.
•The currently selected channel is automatically chosen (without pressing ENTER) after 5 seconds.
Saving channel presets
This receiver can memorize up to 30 channels, stored in three banks, or classes, (A, B and C) of 10 channels each.
1 Select the channel you want to memorize.
See Selecting channels and browsing by genre above.
2 Press T.EDIT.
The display shows a blinking memory class.
3Press CLASS to select one of the three classes, then press / to select the channel preset you want. You can also use the number buttons to select a preset.
4Press ENTER.
After pressing ENTER, the preset class and number stop blinking and the receiver stores the SIRIUS channel.1
Tip
•You can also press MEM (Memory) during reception display to save the information of up to five songs. See Using the SIRIUS Menu below to recall this information.2
Using the SIRIUS Menu
The SIRIUS Menu provides additional SIRIUS Radio features.2
1Press TOP MENU.
2Use / to select a menu item, then press ENTER. Choose from the following menu items:
•Channel Skip/Add – Use / and ENTER to select channels you would like to remove/restore from/to the channel guide.
•Parental Lock – Use / and ENTER to select channels you would like to place under parental lock. Channels put under parental lock are not displayed in the Channel Guide, but may be accessed by directly inputting their channel number and providing the parental lock password.
•Antenna Aiming – Check the strength of satellite and terrestrial reception.
•Memory Recall – Use / to browse your saved song information (see Tip above).
•Password Set – Set the parental lock password.
3When you’re finished, press TOP MENU to return to the reception display.
Connecting the multichannel analog inputs
For DVD Audio and SACD playback, your DVD player may have 5.1, 6.1 or 7.1 channel analog outputs (depending on whether your player supports surround back
Listening to channel presets
You will need to have some presets stored to do this.
1Press CLASS to select the class in which the channel is stored.
Press repeatedly to cycle through classes A, B and C.
2Press / to select the channel preset you want.
•You can also use the number buttons on the remote control to recall the channel preset.
channels).2 Make sure that the player is set to output multichannel analog audio.
1Connect the front, surround, center and subwoofer outputs on your DVD player to the corresponding MULTI CH IN jack on this receiver.
•Use standard RCA/phono jack cables for the connections.
2If your DVD player also has outputs for surround back channels, connect these to the corresponding MULTI CH IN jacks on this receiver.
•Use standard RCA/phono jack cables for the connections.
•If there is a single surround back output, connect it to the SURROUND BACK L (Single) jack on this receiver.
•To use a
Note
1You can reset the Channel presets, Memory, Channel Skip/Add, Parental Lock and Password settings in Resetting the system on page 75.
2To listen to multichannel analog audio you’ll need to select MULTI CH IN (see Selecting the multichannel analog inputs below for more on this).
57
En
