Additional information | 12 |
Web Control
Symptoms | Causes | Remedies | |
Top Menu screen is not | This receiver’s IP address has not been entered | Check the receiver’s IP address and enter it | |
displayed on browser. | into the browser correctly. | correctly in the browser (page 85). | |
|
|
| |
Receiver cannot be operated | JavaScript is disabled on the internet browser. | Enable JavaScript. | |
from browser. |
|
| |
The browser is not compatible with JavaScript. | Use an internet browser that is compatible with | ||
| |||
|
| JavaScript. |
Receiver’s power does not turn on when the power is turned on using the Web Control function.
Network Standby at Network Setup is set to OFF.
Set Network Standby at Network Setup to ON (page 86).
HDMI
Symptom | Remedy |
The HDMI indicator blinks | • Check all the points below. |
continuously. |
|
|
|
No picture or sound. | • This receiver is |
| compatible. If they are not, please connect them using the component or composite video jacks. |
| • Depending on the connected source component, it’s possible that it will not work with this receiver |
| (even if it is |
| between source and receiver. |
| • If the problem still persists when connecting your HDMI component directly to your monitor, |
| please consult the component or monitor manual or contact the manufacturer for support. |
| • If video images do not appear on your TV, try adjusting the resolution, DeepColor or other setting |
| for your component. |
| • While analog video signals are being output over HDMI, use a separate connection for audio |
| output. |
| • To output signals in DeepColor, use an HDMI cable (High Speed HDMI® Cable) to connect this |
| receiver to a component or TV with the DeepColor feature. |
|
|
No picture. | • Try changing the Resolution setting (in Setting the Video options on page 61). |
| • |
| HDMI output |
No sound, or sound suddenly ceases.
•Check that the HDMI AV setting is set to AMP/THROUGH.
•If the component is a DVI device, use a separate connection for the audio.
•If analog video is being output over HDMI, please use a separate connection for the audio.
•Check the audio output settings of the source component.
•HDMI format digital audio transmissions require a longer time to be recognized. Due to this, interruption in the audio may occur when switching between audio formats or beginning playback.
•Turning on/off the device connected to this unit's HDMI OUT terminal during playback, or disconnecting/connecting the HDMI cable during playback, may cause noise or interrupted audio.
Noisy or distorted picture.
•Sometimes a video deck may output a noisy video signal (during scanning, for example), or the video quality may just be poor (with some video game units, for example). The picture quality may also depend on the settings, etc. of your display device. Switch off the video converter and reconnect the source and display device using the same type of connection (component or composite), then start playback again.
•If the problem still persists when connecting your HDMI component directly to your monitor,
please consult the component or monitor manual or contact the manufacturer for support.
HDCP ERROR shows in the display.
•Check whether or not the connected component is compatible with HDCP. If it is not compatible with HDCP, reconnect the source device using a different type of connection (component or composite). Some components that are compatible with HDCP still cause this message to be displayed, but so long as there is no problem with displaying video, this is not a malfunction.
When Control with HDMI is set to ON, the HDMI Input assignment at Input Setup is canceled.
•Even when Control with HDMI is set to ON, for Digital In assignment of HDMI 1 is not canceled, so in this case use the HDMI 1 input.
95
En