Pioneer VSX-21 manual Clearing the Remote Control Settings, Set Up, Preparations

Preparations

3 Press % or fi repeatedly to display the name of the component’s manufacturer.

SIGNAL	SP A	SIGNAL	SP A	SIGNAL	SP A
SELECT		SELECT		SELECT
ANALOG		ANALOG		ANALOG

	dB		dB		dB
(“VCR” is displayed on VSX-D508)
		SIGNAL	SP A	SIGNAL	SP A
		SELECT		SELECT
		ANALOG		ANALOG
			dB		dB

A list of all available preset codes is provided on page 56.

4 Point the remote toward the component to be controlled, enter the 3 digit setup code.

When you enter the setup code, the remote emits a power ON/OFF signal. If the component turns ON or OFF, you have entered the proper code.

If the component does not turn ON or OFF and there is more than one setup code, press ! or ⁄ to select another code in step 3 or try inputting another code (starting again from step 2).

Some manufacturers use several sets of remote control signals and the first code may not correspond to your component.

	SP A		SP A
SIGNAL		SIGNAL
SELECT		SELECT
ANALOG		ANALOG
	dB		dB
SIGNAL	SP A	SIGNAL	SP A
SELECT		SELECT
ANALOG		ANALOG
	dB		dB

Repeat steps 2 through 4 to assign preset codes for as many components as necessary.

5 Press COMMANDER SET UP to exit the preset mode.

The remote control returns to the previous operation mode.

memo • When operating a PIONEER’S DVD/LD player, set the manufacturer code to “000” in the preset mode.

•All codes enrolled in the manufacturer code list can be set even if a code is not displayed.

•RECEIVER cannot be preset.

Clearing the Remote Control Settings

SET UP

	DSP MODE			MIDNIGHT
	1	2	3	4
	CH.SELECT TEST TONE		ATT	SIG.SELECT
	5	6	7	8
0	CN.LEVEL			EFFECT
	9	0	+10	MEMU
			CLASS TV/VCR
	FUNCTION	DIRECT		FL DIMMER
	MODE CHECK			COMMANDER
				SET UP

Î

AUDIO/VIDEO PRE-PROGRAMMED

REMOTE CONTROL UNIT

Clears all presets and restores factory installed presets.

Press the COMMANDER SET UP and 0 at the same time for more 3 seconds.

• All the multi-control buttons on the remote control blinks. After

COMMANDER blinking three times, all the settings are canceled.

SET UP

23

<ARB7181>