Pioneer VSX-21 Recording from Video Components, Set Up, Other Operations, Load the DVD or LD, etc

Other Operations

Recording from Video Components

The following operations show you how to record audio and video to the video tape recorder connected to the VCR 1 or VCR 2 jacks.

memo The receiver’s volume, balance, tone (BASS, TREBLE, and LOUDNESS), and surround effects have no effect on the recorded signal.

RECEIVER		TV	1 Select the component you want to record.
			Be sure to press SIG. SELECT on the remote or SIGNAL SELECT on the
MUTING		TV	front panel to choose “ANALOG”. (Refer to “Switching ANALOG/
	FQ	FUNC	DIGITAL signal input” on page 29.)
	+
	ENTER

SET UP

–

FQ

VOLVOL

CHANNEL

MULTI CONTROL

DVD/LD TV/SAT CD

VCR 1	TV CONTROL		TUNER
VCR 2	RECEIVER		MD/TAPE
	DSP MODE		MIDNIGHT
1	2	3	4
CH.SELECT	TEST TONE	ATT	SIG.SELECT
5	6	7	8
CN.LEVEL			EFFECT

2	Prepare the program source.
	(Load the DVD or LD, etc.)
3	Insert a blank tape into the video tape recorder (VCR 1).
4	Start recording on the video tape recorder, then start
SIG. SELECT	playback from the source component.

	9	0	+10	MEMU
1			CLASS TV/VCR
	FUNCTION		DIRECT	FL DIMMER
	MODE CHECK			COMMANDER
				SET UP

Î

AUDIO/VIDEO PRE-PROGRAMMED

REMOTE CONTROL UNIT

memo • Recording cannot be made from analog to digital, and similarly from digital to analog.

•When recording a DVD, the recorded image may flicker or be difficult to view because of the copy protection signal programmed on the DVD.

OPERATION

SIGNAL SELECT

1

43

<ARB7181>