Sound Modes
Playing Sources with Dolby Digital or DTS Sound
RECEIVERTV
| MUTING |
| TV |
| FQ | FUNC | |
|
| + |
|
|
| ENTER |
|
|
| – |
|
|
| FQ |
|
5 | VOL |
| VOL |
| CHANNEL |
|
1 Follow steps 1 to 3 of the playback procedure. (Refer to “Playback” on page 40.)
1Turn on the power of the playback component.
2 Press RECEIVER to turn on the receiver.
3 Press FUNCTION to select the source component you want to play.
MULTI CONTROL
3
2
DVD/LD | TV/SAT | CD | |
VCR 1 | TV CONTROL | TUNER | |
VCR 2 | RECEIVER | MD/TAPE | |
DSP MODE |
| MIDNIGHT | |
1 | 2 | 3 | 4 |
CH.SELECT TEST TONE | ATT | SIG.SELECT | |
5 | 6 | 7 | 8 |
CN.LEVEL |
| EFFECT | |
9 | 0 | +10 | MEMU |
|
| CLASS TV/VCR | |
FUNCTION | DIRECT | FL DIMMER | |
MODE CHECK |
|
| COMMANDER |
|
| SET UP |
Î
AUDIO/VIDEO
REMOTE CONTROL UNIT
2 Press SIG.SELECT on the remote control or SIGNAL SELECT on the front panel to select DIGITAL.
(Refer to “Switching ANALOG/DIGITAL signal input” on the previous page.)
3 Press to switch the Dolby/DTS mode on.
Each press changes the Dolby/DTS mode.
(Refer to “Switching the Dolby/DTS mode” on page 32.)
4 Start playback of the component you selected in step 1.
5 Press VOL
3
memo
• When an LD or CD player compatible with DTS is played back with SIGNAL SELECT set in “ANALOG”, digital noise is output caused by playing back the DTS directly (no decoding). To prevent noise, you need to make digital connections (Refer to pages 20, 21) and set SIGNAL SELECT to “DIGITAL”.
2 5
memo
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the
Refer to pages 52, 53 for explanations of Dolby Digital, Dolby Pro Logic, and DTS.
30
<ARB7181>