Pioneer VSX-918V-K, VSX-818V-K manual Additional information, VSX-918V model only The SR

12Additional information

Problem	Remedy
Considerable noise in radio	• Connect the antenna (page 19) and adjust the position for best reception.
broadcasts.	• Route any loose cables away from the antenna terminals and wires.
	• Fully extend the FM wire antenna, position for best reception, and secure to a wall
	(or connect an outdoor FM antenna).
	• Connect an additional internal or external AM antenna (page 19).
	• Turn off equipment causing interference or move it away from the receiver (or
	move antennas farther away from equipment causing noise).
Broadcast stations cannot be	• Connect an outdoor antenna (refer to page 19).
selected automatically.
Noise during playback of a	• Move the cassette deck away from your receiver, until the noise disappears.
cassette deck.
Sound is produced from other	• Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG according to the type of
components, but not from LD	connections made (refer to page 36).
or DVD player.	• Set the digital input settings correctly (refer to page 64).
	• Make digital connections (refer to page 12) and set the SIGNAL SELECT to DIGITAL
	(refer to page 36).
	• Refer to the instruction manual supplied with the DVD player.
No sound is output or a noise	• Set the digital volume level of the player to full, or to the neutral position.
is output when software with	• Make sure the player’s settings are correct and/or the DTS signal out is on. Refer
DTS is played back.	to the instruction manual supplied with the DVD player.
	• Set the input signal type to DIGITAL (see Choosing the input signal on page 36).
During a playback search,	• This is not a malfunction, but be sure to turn the volume down to prevent the
noise is output from a DTS	output of loud noise from your speakers.
compatible CD player.
Everything seems to be set up	• Check that the positive/negative speaker terminals on the receiver are matched
correctly, but the playback	with the corresponding terminals on the speakers (see Connecting the speakers on
sound is odd.	page 20).
There seems to be a time lag	• See Automatically setting up for surround sound (MCACC) on page 8 to set up your
between the speakers and the	system again using MCACC (this will automatically compensate for a delay in the
output of the subwoofer.	subwoofer output).
After using the Auto MCACC	• Low-frequency noise could have been caused by an air conditioner or motor.
Setup, the speaker size setting	Switch off all appliances in the room and rerun the Auto MCACC Setup.
(LARGE or SMALL) is incorrect.
Can’t operate the remote	• Replace the batteries (refer to page 6).
control.	• Operate within 7 m, 30° of the remote sensor (refer to page 29).
	• Remove the obstacle or operate from another position.
	• Avoid exposing the remote sensor on the front panel to direct light.
	• VSX-918V model only: Unplug anything connected to the CONTROL IN jack and
	use remote normally (see Operating other Pioneer components on page 51).
VSX-918V model only: The SR	• Reinsert the SR cable, making sure it’s connected to the right jack (see Using this
cable is connected, but the	receiver with a Pioneer flat screen TV on page 62).
connected components can’t	• Make sure an analog connection has been made between the units.
be operated with the remote.	• This feature only works with Pioneer products.
The display is dark or off.	• Press DIMMER on the control repeatedly to return to the default.
The System Setup screen	• When the receiver is in standby, switch to BURST.OFF by holding down
doesn’t appear.	ACOUSTIC EQ (front panel) and pressing STANDBY/ON (the current setting is
	displayed).

68

En