03 Connecting up
Connecting digital components
For proper decoding of Dolby Digital/DTS soundtracks, you need to make digital audio connections. You can do this by either coaxial or optical connections (you don’t need to do both). The quality of these two types of connections is the same, but since some digital components only have one type of digital terminal, it is a matter of matching like with like (for example, the coaxial output from the component to the coaxial input on the receiver). This receiver has both a coaxial and an optical input for a total of two digital inputs. Connect your digital components as shown below.
When connecting your equipment, always make sure the power is turned off and the power cord is disconnected from the wall outlet.
DIGITAL
OUT (OPTICAL)
CD player
|
| The arrows |
DIGITAL |
| indicate the |
| ||
| direction of the | |
OUT |
| |
| audio signal. | |
(COAXIAL) |
|
DVD player
Connecting audio components
To begin set up, connect your analog audio components (such as a cassette deck) to the jacks. For components you want to record with, you need to hook up four plugs (a set of stereo ins and a set of stereo outs), but for components that only play, you only need to hook up one set of stereo ins (two plugs). You should also hook up your digital components to analog audio jacks if you want to record to/from digital components (like an MD) to/from analog components. See above for more on digital connections.
When connecting your equipment, always make sure the power is turned off and the power cord is disconnected from the wall outlet.
ANALOG 
OUT
CD player
ANALOG 
IN (REC)
ANALOG
OUT (PLAY)
12
En
The arrows indicate the direction of the audio signal.
