Additional information 11

69

En

Frequency response

DVD/LD,
TV/SAT

MONITOR . . . 5 Hz to 40 MHz dB
Signal-to-Noise Ratio. . . . . . . . . . . . . . . . . 55 dB

FM Tuner Section

Frequency Range. . . . . . . 87.5 MHz to 108 MHz
Usable Sensitivity . . . . . . . . Mono:13.2 dBf, IHF
(1.3 µV/ 75

)
50 dB Quieting Sensitivity. . . . . . Mono: 20.2 dB
. . . . . . . . . . . . . . . . . . . . . . . . . . .Stereo: 38.6 dBf
Signal-to-Noise Ratio. . . . . . . . . . . Mono: 73 dB
(at 85 dBf)
Stereo: 70 dB (at 85 dBf)
Distortion . . . . . . . . . . . . . .Stereo: 0.5 % (1 kHz)
Alternate Channel Selectivity . . . . . . . . . . 60 dB
(400 kHz)
Stereo Separation . . . . . . . . . . . . . 40 dB (1 kHz)
Frequency Response. . . . . . . . . 30 Hz to 15 kHz
(±1 dB)
Antenna Input (DIN) . . . . . . . .75

unbalanced

AM Tuner Section

Frequency Range. . . . . . . .530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna). . . . . . 350 µV/m
Selectivity . . . . . . . . . . . . . . . . . . . . . . . . . . 25 dB
Signal-to-Noise Ratio. . . . . . . . . . . . . . . . . 50 dB
Antenna . . . . . . . . . . . . . . . . . . . . .Loop antenna

Miscellaneous

Power Requirements. . . . . . . . . AC 120 V, 60Hz
Power Consumption . . . . . . . . . . .300W, 420 VA
In standby . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W
AC Outlet . . . . . . . . . 100 W MAX. (SWITCHED)
Dimensions . . . 420 (W) x 158 (H) x 401 (D) mm
(16-9/16 (W) x 6-1/4 (H) x 15-13/16 (D) in.)
Weight (without package). . . . . 10.6 kg (23.4 lb)

Furnished Parts

AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . .1
FM wire antenna. . . . . . . . . . . . . . . . . . . . . . . . .1

AA/LR6 dry cell batteries

. . . . . . . . . . . . . . . . .2
Remote control . . . . . . . . . . . . . . . . . . . . . . . . .1
Warranty Card. . . . . . . . . . . . . . . . . . . . . . . . . . .1

Microphone (

VSX-D914 model only

). . . . . . . 1
Microphone stand

(

VSX-D914 model only

)

. 1

These operating instructions. . . . . . . . . . . . . . .1

Specifications and the design are subject
to possible modifications without notice,
due to improvements.

* Measured pursuant to the Federal Trade
Commission’s Trade Regulation rule on Power
Output Claims for Amplifiers.
** Measured by Audio Spectrum Analyzer.

Cleaning the unit

Use a polishing cloth or dry cloth to wipe
off dust and dirt.
When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser
diluted five or six times with water, and
wrung out well, and then wipe again with
a dry cloth. Do not use furniture wax or
cleansers.
Never use thinners, benzine, insecticide
sprays or other chemicals on or near this
unit, since these will corrode the surface.
11_additional_info.fm 69 ページ 2003年12月9日 火曜日 午前11時3分