Connecting up 02

11

En

English
Connecting using the component video output

You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other
equipment). This should give you the best
quality picture from the three types of video
output available.

• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.

Watching progressive scan video

from the component video outputs

This player can output progressive scan video
from the component video output. Compared
to interlace video, progressive scan video
effectively doubles the scanning rate of the
picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive
scan TV, see

Video Output settings

on page 33.
When the player is set to output progressive
scan video, the

PRGSVE

indicator lights in the
front panel display.

Important

• If you connect a TV that is not compatible
with a progressive scan signal and switch
the player to progressive, you will not be
able to see any picture at all. In this case,
switch everything off and reconnect using
the supplied video cable (see

Easy
connections

on page 9), then switch back
to

Interlace

(see below).

Switching the video output to interlace

using the front panel controls

Switch the player to standby then, using the
front panel controls, press

STANDBY/ON

while pressing

to switch the player back to

Interlace

.
S
VIDEO OUT
COMPONENT VIDEO OUT
AUDIO OUT
COAXIAL
OPTICAL
DIGITAL AUDIO OUT
VIDEO
OUT
P
R
P
B
Y
TV
S-VIDEO
IN
L
12
R
L
R
S
VIDEO OUT
COMPONENT VIDEO OUT
AUDIO OUT
COAXIAL
OPTICAL
DIGITAL AUDIO OUT
VIDEO
OUT
PR
PB
Y
R
TV
COMPONENT
VIDEO IN
L
12
R
STANDBY/ON
STANDBY/ON

OPEN/CLOSE
DV470_WY.book 11 ページ ２００４年３月２５日　木曜日　午後６時５６分