Locking the Remote
To lock and unlock the remote control, hold the F1 button down for 10 seconds.
IR Sensor and LED Indicators
The IR sensor is located on the bottom right side of the front bezel. To operate the remote control, point the remote directly at the IR sensor. Make sure the batteries are installed in the remote before operation.
The LED indicator light is located in the IR sensor window. The following table explains the condition for each of the indicators.
LED Status | Condition |
|
|
Green | Display turned on but no input detected |
|
|
Red | Display turned off |
|
|
Off | Display turned on and input detected |
|
|
Using the Display in Portrait Mode
When looking at the rear of the display in landscape orientation, rotate the display
Caution: Improper ventilation may shorten the life of the display.
Using the Display in Flat Orientation
The PS7050 and PS7050T are not recommended for use in flat orientation for tabletop, floor, or ceiling installations. LCD panels of this size are at risk of panel deflection which can cause cosmetic sagging, brightness uniformity issues, and shortened life span.
Turning the PS7050/PS7050T On
1)Insert the power cord into the display and the power outlet.
2)Press the power button on the remote or keypad.
Turning the PS7050/PS7050T Off
With the power on, press the power button on the remote or keypad to put the LCD panel in a standby mode. To turn off power completely, disconnect the AC power cord from the power outlet.
Note: If there is no signal for a 10 minutes on a HDMI, DisplayPort, or Component signal or 1 minute on a VGA signal and the Auto Sleep OSD setting is set to On, the LCD panel will automatically go into standby mode.
PS7050/PS7050T User Manual 9
