Manuals / Brands / Computer Equipment / Switch / Planet Technology / Computer Equipment / Switch

Planet Technology FGSW-2402PVS Solution:, Solution:, Solution:, Solution:, The other port, Performance is bad, The Link LED is not lit, Why the Switch doesn’t connect to the network

1 50

Download 50 pages, 4.5 Mb

/8'0#)

This chapter contains information to help you solve problems. If the Ethernet Switch is not functioning properly, make sure the Ethernet Switch was set up according to instructions in this manual.

The Link LED is not litSolution:

Check the cable connection and remove duplex mode of the Ethernet Switch

Some stations cannot talk to other stations located onThe other port

Solution:

Please check the VLAN settings, trunk settings, or port enabled / disabled status.

Performance is bad

Solution:

Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to full duplex and the partner is set to half duplex, then the performance will be poor. Please also check the in/out rate of the port.

Why the Switch doesn’t connect to the network

Solution:

Check the LNK/ACT LED on the switch

Try another port on the Switch

Make sure the cable is installed properly

Make sure the cable is the right type

Turn off the power. After a while, turn on power again

Contents

Page FCC Warning CE Mark Warning Revision INSTALLATION 3. CONSOLE CONFIGURATION 4. WEB CONFIGURATION Page Page Model FGSW-2402PVS FGSW-2620PVS Switch Management Standards Conformance System Per 10/100Mbps port section 3.2.4 Port Configuration Note: Step5: Supply power to the Switch 19-inch Caution: 2.2.1 Desktop Installation Page admin Misc Configuration Item Description “ Enter” 1. Port Status section 2. Port Configuration 3. Trunk Configuration 4. VLAN Configuration Object Port Configuration “TAB” “Space Bar” “ESC” Note: ObjectDescription 3.2.6.1 Create a Port-BasedVLAN Group Add Add a PortBased VLAN Group "Space Bar Add a PortBased VLAN Group 3.2.6.2 Edit a VLAN Group 3.2.6.3 Delete a VLAN Group 3.2.6.4 Return to Main Menu “Operation completed successfully!” Bandwidth control 3.2.10.1 Advanced Switch Configuration 3.2.10.2 Password Setting 3.2.10.3 Reset System Default Setting 3.2.10.4 Reboot System 3.2.10.5 System Information 3.2.10.6 IP Configuration 3.2.10.7 Return to Main Menu 3.2.11.1 Advanced Switch Configuration 3.2.11.2 POE Port Status 3.2.11.3 Return to Main Menu “IP Address” Web IP subnet address http://192.168.0.100 “admin” Port Configuration: Trunk Configuration: VLAN Configuration: Port Mirroring Configuration: QoS Configuration: "Apply “Back” “Add NEW” “Delete” Disable RX & TX Disable QoS Priority High empty then Low High: Low=3:1 High: Low=5:1 High: Low=7:1 InRate OutRate Advanced Switch Configuration: Password Setting: Reset System Default Setting: Reboot System: System Information: Collision Retry Forever: MAC Table Auto-Aging: Disable, 150 sec, 300 sec, 600 sec MAC Table Hashing: CRC Hash and Direct Map Web Auto Logout Time: 5min, 10min, and 20min Password protection User Name New Password “OK” Page POE Ports POE Port Status: Page If attached device is: 100Base-TXport will set to: The Link LED is not lit Solution: Some stations cannot talk to other stations located on The other port Performance is bad Contact MDI MDI-X RJ-45Connector pin assignment The standard cable, RJ-45pin assignment Figure A-1: Straight-Throughand Crossover Cable