Planet Technology WMRT-414 Chapter 2 Hardware Installation, 2.1Hardware Connection, RJ-45, Note:, RESET, Connect, Connect, WMRT-414, cable to, WMRT-414, LAN port, RESET Button

Chapter 2 Hardware Installation

Before you proceed with the installation, it is necessary that you have enough information about the WMRT-414.

2.1Hardware Connection

1.Locate an optimum location for the WMRT-414. The best place for your WMRT-414 is usually at the center of your wireless network, with line of sight to all of your mobile stations.

2.Adjust the antennas of WMRT-414.Try to adjust them to a position that can best cover your wireless network. The antenna’s position will enhance the receiving sensitivity.

3.Connect RJ-45 cable to WMRT-414 LAN port. Connect one of the LAN ports on WMRT-414 to your LAN switch/hub or a computer with a RJ-45 cable.

4.Connect RJ-45 cable to WMRT-414 WAN port. Connect xDSL/Cable Modem to the WAN port on WMRT-414. Usually, this cable would be provided with your modem. If no cable was supplied with your modem, please use a RJ-45 Ethernet cable

5.Plug in power adapter and connect to power source. After power on, WMRT-414 will start to operate.

Note: ONLY use the power adapter supplied with the WMRT-414. Otherwise, the product may be damaged.

If you want to reset WMRT-414 to default settings, press and hold the RESET button over 10 seconds and release. And then wait for WMRT-414 restart.

RESET Button This button has two functions:

To Reboot machine without Clearing Existing Configurations:

Press the reset button with a pencil tip (for less than 5 seconds), machine will re-boot itself, the existing configurations will be kept.

To Clear All Data and restore the factory default values:

Press the reset button for longer than 10 seconds and the router will reset itself to the factory default settings (warning: your original configurations will be replaced with the factory default settings)

- 3 -