Add a Rule | Fill in the "Source IP Range", "Destination IP Range”, |
| “Source Port Range”, "Destination Port Range", |
| "Protocol" or "WAN Port" of the setting to be added and |
| then click "Add". Then this rule of Protocol and Port |
| Binding will be added into the "Protocol and Port Binding |
| Table" below. If you find any typo before adding it and |
| want to retype again, just click "Clear" and the fields will |
| be cleared. |
Remove a Rule | If you want to remove some rule of Protocol and Port |
| Binding from the "Protocol and Port Binding Table", |
| select the rules you want to remove in the table and then |
| click "Delete Selected". If you want remove all rules from |
| the table, just click "Delete All" button. Click "Reset" will |
| clear your current selections. |
Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance sections or start using the router (with the advance settings in place)
3.4.6 ALG Settings
You can select applications that need “Application Layer Gateway” to support.
Parameters | Default | Description |
Enable |
| You can select to enable “Application Layer |
|
| Gateway” of an application and then the router |
|
| will let that application correctly pass though the |
|
| NAT gateway. |
|
|
|
|
| 44 |