DISTINCTIVE RINGER SETUP
ADJUSTING THE HEADSET VOLUME
TIP
See ”Storing Phone Numbers, Names, Distinctive Rings, and Speed Dial” on page 17 for storing a Distinctive Ring in the Phonebook.
“Distinctive Ringer” allows you to preset memory locations with a designated ring tone. When an incoming call is received and the Caller ID information matches the information in one of the memory locations, the Distinctive Ring that has been stored for that particular caller will sound.
If you have set multiple memory locations with distinctive rings, switching the setting to “Distinctive Off” will result in no distinctive ringing. All incoming calls will have a normal
The remote headset volume settings (Volume Low, Volume Medium, Volume High, and Volume Maximum) can only be adjusted during a call. Press ▲ or ▼ to select the volume setting. When you hang up, the phone keeps the last volume setting selected.
TIP
When you press
▲in maximum volume level or ▼ in lowest volume level, an error tone sounds.
BASICS
ring tone. Switching to “Distinctive On” will activate all programmed distinctive ring
MUTE MICROPHONE
memory locations.
1) When the phone is in the standby mode, press MENU/MUTE.
2) Press ▲ or ▼ to move the pointer to “Distinct. Ring”, then press SELECT/CH.
3)Press ▲ or ▼ to choose “Distinctive On” or “Distinctive Off”.
4)Press SELECT/CH, and you will hear a confirmation tone.
5)Press END to exit.
You can temporarily
turn Off the micro-
phone so that the person you are talking with cannot hear you.
1) During a telephone call press and hold
MENU/MUTE for a few seconds to turn
Off the microphone, and “Mute” appears on the display.
2) Press MENU/MUTE again to cancel muting.
TIP
Do not press END to cancel muting. END will disconnect the call and the phone will return to standby mode.
10
11
