![](/images/new-backgrounds/1304558/3045589x1.webp)
I N S T A L L A T I O N S T E P S
S T E P 2 attach to
phone and headset
1. Unplug your telephone’s handset cord from the telephone base.
2. Plug your telephone’s handset cord into the Switcher amplifier handset jack ( ).
3. Connect your telephone base to the Switcher amplifier telephone jack ( )
using the short curly cord. On your telephone base, plug the short curly cord into the outlet normally used for your handset.
4. Plug the headset cord into the Quick Disconnect™ (QD) module on the long curly cord coming from the front of the amplifier.
| The QD will allow you to disconnect the headset |
| from the amplifier when you are not using the |
| phone, or need to move away from the amplifier, |
2 | while leaving your headset in place. |
|
I N S T A L L A T I O N S T E P S
S T E P 3 set default
settings
These are the default settings for headset use.
1. Headset/Handset Selector is switched to
Headset ( ).2
3
4
5
6
2. Telephone/Computer Audio Switch is released
(no colored indicator showing). | 2 |
4 | |
| 3 |
| 5 |
3. Microphone Switch is released | 6 |
| |
(no colored indicator showing). |
|
4. Incoming Volume Thumbwheel is set to 4.
5. The Outgoing Volume Control has been | 2 |
3 | |
5 | |
| 4 |
You can adjust it when you place your first call | 6 |
| |
(see page 6). |
|
e n g l i s h | 3 |