Plantronics WO300 Base set-up, Attaching charging cradle to base, Connecting base to desk phone

2 Base set-up

2.1 Attaching charging cradle to base

1Connect the headset charging cradle to the base. Push firmly on the cradle until the cradle snaps into place.

2.2 Connecting base to desk phone

1Connect the telephone interface cable to the telephone interface cable jack on the base.

2Disconnect the handset coil cord from the desk phone.

3Connect the telephone interface cable to the now open handset port on the desk phone.

4Connect the handset coil cord to the telephone interface cable junction box.

5Place the handset back on the telephone cradle.

Note If your phone has a built-in headset port, you should only use the headset port if you will not be using the HL10 lifter. In this configuration, you must press both the headset button on your phone and the call control button on the headset to answer or end calls.

2.3 Connecting power supply to base

1Connect the base power supply into the power jack on the base.

2Connect the power supply to outlet.

2.4 Positioning base

The minimum recommended separation between your desk phone and the base is 15 cm.

The minimum recommended separation between the base and computer is 30 cm. Incorrect position can cause noise and inter- ference problems.

30 cm

15 cm

Plantronics Savi User Guide 7