Names of the Remote Control Parts/Preparing the Remote Control
There are two types of remote control units included with the U5 series of projectors. Both types are described below. Refer to the description (and diagram) for the remote control unit included with your projector.
Names of Parts/Preparing the Remote Control Unit | Applicable Projector: |
Included with the |
|
Names of the Remote Control Parts |
|
STANDBY button
Infrared transmitter
Laser transmitter
STANDBYLASER
LASER button
(Turns the laser point on and off)
Buttons used for input selection
RGB button and VIDEO button (VIDEO /
RGB VIDEO AUTO
MENUQUICK
Q |
AUTO button
(Automatic adjustment of the RGB moving image)
QUICK button
Buttons used for menu operations
The , , and buttons are the select (, , and ) buttons.
FREEZE button
VOL button
ENTERCANCEL
FREEZE MUTE TIMER
1 | 2 |
VOL ZOOM
3 | 4 |
Buttons used for the PC mouse function
(JOG button and
TIMER button
MUTE button
(Temporarily cancels the video and audio)
ZOOM button
Number buttons
Note:
If a button on the remote control unit is held in con- tinuously for approximately 30 seconds, signal transfer will be suspended. To resume transferring signals, press the button again.
Also, to use the jog button after signal transfer has been suspended, first press any other button, then press the jog button.
Inserting the Batteries
When using the remote control for the first time, install the batteries that were supplied.
1 Slide the battery compartment cover (located on the bottom of the remote control) and pull off.
2 Insert the batteries to match the "+" and
3 (A) Leaving a little space in the front, close the lid, (B) then with the back pressed tightly,
(C) press the lid towards the front.
(A) | (B) |
(C) |
CAUTION
When replacing batteries, purchase two of the same type of AAA battery. Heed the regulations in effect in your region on the disposal of spent batteries.