BRACKET MOUNT
For more solid mounting, screw the bracket directly into a
To bracket mount the Sat30, you will need the following hardware:
•Sat30 Loudspeaker
•Rubber Bumper (optional)
•2 #6 Pan Head Screws
•Sat30 Mounting Template
Instructions:
1.Determine where you want to mount the loudspeaker.
2.Hold the mounting template to the mounting surface and mark the screw hole locations with a pencil.
3.Use an 1/8" drill bit and drill
the mounting holes (if necessary). Note: Use wall anchors if mounting the loudspeaker into drywall.
4.Loosen the knob on the back
of the loudspeaker so it can swivel.
Note: The loudspeaker bracket has a notch for the speaker wires, which allows you to run the speaker wires up the mounting surface, or you may drill a hole in the mounting surface and run the speaker wires through the hole.
5.Place the rubber bumper underneath the bracket (optional).
6.Hold the loudspeaker to the mounting surface.
7.Attach the loudspeaker assembly using the supplied #6 pan head screws.
8.Once the loudspeaker has been adjusted to the desired angle, tighten the knob on the back of the loudspeaker to hold it in place.
Mounting Template |
2" (5.08cm) |
WARNING: Aiming the Sat30 to an angle greater than 45 degrees to the horizontal may result in water buildup inside the grille that could cause damage to the speaker, especially during cold weather when freezing may occur.
Atrium Sub10
PAINTING THE Sub10 SUBWOOFER
While the Atrium Sub10 has a color- impregnated finish that enables it to blend in with your landscaping and outdoor furnishings, the cabinet is paintable. Should you choose to paint your speakers, follow these instructions:
Before you begin, you will need:
•A spray can of primer paint
(Krylon Sandable Spray Primer #1318).
•A spray can of the outdoor paint of your choice.
•Masking tape.
•Paint mask (not included) to cover
PREPARING TO PAINT
1.Carefully mask off the following:
•Driver
•Eyebolt
•Cable
PAINTING THE CABINET
1.Apply two thin coats of primer to the cabinet.
2.When the primer is completely dry, apply the finish color. Multiple coats may be required for a consistent look.
3.When the paint is completely dry, remove the masking material.
4.Try to keep all handling of freshly painted parts to a minimum.
10 | Polk Audio Customer Service | Customer Service Hours of Operation: | polkcs@polkaudio.com | 11 |