Polk Audio Sat30, Sub10 owner manual Pendant Mount, Instructions

PENDANT MOUNT

To pendant mount the Sat30, you will need the following hardware:

•Sat30 Loudspeaker

•Eyebolt (with nut)

•(1) 1/4" Split Ring Lock Washer

•Two Faston Connectors

•Pendant Cable (not included)

•Loudspeaker Wire (not included)

•Pendant Cap

Eyebolt

Nut	Pendant
	Cable
Lock Washer
Pendant
Cap
Cabinet

Instructions:

Note: A pendant cable (not included) is required to hang the Atrium Sat30 loudspeaker from a ceiling or overhead beam. Use a cable that meets or exceeds the safety and/or building codes applicable to the mounting situation. The speaker weighs 3.5 lbs. on its own.

1.Determine how far down from your ceiling or beam you want your loudspeaker to hang.

2.Secure the pendant cable to the ceiling or beam and run loudspeaker wire along the pendant cable.

3.Attach the supplied faston connectors to the loudspeaker wires.

(Large = “+”, Small = “–”)

4.Expose the loudspeaker spade terminals on the back of the cabinet by removing the knob, clamp and bracket.

5.Disconnect the existing loudspeaker wire from the spade terminals using needle-nose pliers and remove the bracket assembly.

6.Thread the new loudspeaker wire through the wire hole in the pendant cap and connect the wires to the loudspeaker spade terminals, observing correct polarity.

7.Attach the pendant cap to the loudspeaker using the eyebolt, lock washer and nut.

8.Secure the pendant cable to the eyebolt.

Caution: Secure mounting is required to prevent personal injury or damage to the loudspeaker.

8 Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600) Customer Service Hours of Operation: Monday-Friday, 9AM-6PM EST polkcs@polkaudio.com 9