Programming the Remote Control
The remote control supplied with your televi- sion will also operate a variety of infrared- controlled accessory devices such as cable boxes, VCRs, DVD players, satellite receivers, and amplifiers.
The TV remote’s default mode at power up and after replacing the batteries is TV. You must press the Select button to switch the remote to one of the accessory
AMP
VCR, DVD, SAT, or AMP.
Depending on the accessory device you have, programming may not be necessary, because default codes for certain accessory devices have already been programmed into the remote. So before attempting to program, try this test:
GUIDE
POWER | SELECT | POWER |
INFO
HIGH DEFINITION
SAT
DVD619 DVD/CD PLAYER
OPEN/CLOSE
DVD
STOP PLAY PAUSE
PREVNEXT
•Press the Select button to cycle through the accessory
•Point the remote toward the accessory device, then press the
1 Press the Select and
2 NOTE: When inputting the digits as described below, you must not allow more than 20 seconds to pass between the input of each digit or you will need to return to step 1 and begin the pro- gramming process again.
Input the appropriate digit provided below for the type of accessory device you want to operate:
1Cable (CBL)
2VCR
3DVD
4Satellite (SAT)
5Amplifier (AMP).
3 Input the
VCR
CBL
1
1
2
3
20