10 | Ceiling DocCam II — Installation |
Configuring for remote controls
The Ceiling DocCam II can be programmed to work with the remotes listed below. DIP switches on the camera enclosure must be configured in order to work with these remotes. See Figure 2 on page 4 for exact location of DIP switches. Use the following diagram to program your Ceiling DocCam II correctly.
|
|
|
| 11 |
|
| Ceiling DocCam II — Installation |
| |||
|
|
|
|
|
|
Programming presets
Presets are used to program defined positions of the camera into a simple, one button preset. You can switch easily from a zoomed in position on a small document to a zoomed out position for documents such as blueprints. This saves the hassle of zooming in and out when presenting documents of a variety of sizes. You can program your ClearOne IR remote with six different presets labeled
Note:These presets will only work with the ClearOne IR remote.
ClearOne Ceiling DocCam II (ONLY)
OFF
ON
1 2 3 4
1=Off 2=Off 3=Off 4=Off
PolyCom IPower 9000
OFF
ClearOne
OFF
ON
1 2 3 4
1=On 2=On 3=On 4=On
PolyCom IPower 600
PictureTel, and 900 Tower
OFF
Polycom
ViewStation,
OFF
ON
1 2 3 4
1=On 2=Off 3=Off 4=Off
Tandberg
OFF
To program a preset
1.Zoom in or out to desired view.
2.Press the Set button once.The
3.Press the selected preset button
Note: If you want to reset a preset, just program a new preset using that same number. The new preset will override the old one.
PRESETS
0 1 2
3 4 5
SET 
ON
1 | 2 | 3 | 4 |
1=Off 2=Off 3=On 4=On
ON
1 | 2 | 3 | 4 |
|
|
|
|
1=On | 2=On | 3=Off | 4=Off |
ON
1 | 2 | 3 | 4 |
|
|
|
|
1=Off | 2=On | 3=On | 4=Off |
Figure 12. Presets
Sony
OFF
ON
1 | 2 | 3 | 4 |
1=Off 2=Off 3=On 4=Off
Sony, PCS1
PCS6000 Codec, PTZ Camera
OFF
ON
1 2 3 4
1=On 2=Off 3=On 4=Off
Aethra
OFF
ON
1 | 2 | 3 | 4 |
1=Off 2=Off 3=Off 4=On
Figure 11. DIP switch configurations
Note: For best performance of the VISCA™ (a trademark of Sony Corporation) commands, set DIP switches to the ClearOne configuration when the camera is connected to the control port of a codec.
Note: After changing the DIP switches, camera must be power cycled.
Technical Services Group ~ | Technical Services Group ~ |
