Polycom RMX 2000 Hardware Guide
Replacing the RTM IP Card
The RTM IP card on the rear of the RMX 2000 provides connectivity to all the MCU modules. Use the following procedure to replace the RTM IP card:
1Ensure that the power switch on the RMX 2000 is turned OFF (O).
2Unscrew the captive screws on the rear panel of the RMX 2000 that secure the RTM IP card.
3Use the metal ejector levers to pull the RTM IP card out of its slot in the backplane.
4Carefully slide the RTM IP card out through the rear panel.
5On the card to be installed, move the ejector levers to their fully open position.
6Slide in the replacement RTM IP card.
7Push the RTM IP card firmly into the backplane, making sure it is properly seated in its slots.
8Ensure that the metal ejector levers are fully retracted into their housings.
9Tighten the captive screws on the rear panel of the RMX 2000 that secure the RTM IP card.
10Turn ON the RMX 2000.
For more information on the Card Configuration Modes after reset, see "MPM/
MPM+ and MPMx Configuration Modes” on page
