3.Rotate arbor cover (B) Fig. 50, and lower guard (G) to the rear, exposing arbor screw (C), as shown.
4.Remove arbor screw (C) Fig. 50, by turning screw clockwise with wrench supplied while at the same time pressing in on arbor lock (D) Fig. 51, to keep the arbor from turning. Remove outside blade flange (E) Fig. 50, and saw blade (F). DO NOT REMOVE INSIDE BLADE
FLANGE.
5.Assemble new saw blade MAKING CERTAIN
TEETH OF SAW BLADE ARE POINTING DOWN AT THE FRONT, AS SHOWN and assemble outside blade flange (E)
Fig. 50, making sure flats on outside blade flange are engaged with flats on arbor shaft.
6.Thread arbor screw (C) Fig. 50, into saw arbor by turning screw (C) counterclockwise as far as possible by hand. Then tighten arbor screw (C) with wrench supplied while at the same time pressing in on arbor lock (D) Fig. 51, to keep arbor from turning.
7.Rotate arbor cover (B) Fig. 50, and lower guard (G) to the front and replace screw that was removed in STEP 2 and securely tighten.
G |
B |
F |
E |
C |
Fig. 50
D
BRUSH INSPECTION
AND REPLACEMENT
CAUTION: BEFORE INSPECTING BRUSHES, DIS- CONNECT THE MACHINE FROM THE POWER SOURCE.
Brush life varies. It depends on the load on the motor. Check the brushes after the first 50 hours of use for a new machine or after a new set of brushes has been installed.
After the first check, examine them after about 10 hours of use until such time that replacement is necessary.
The brush holders (A) Fig. 52, are located on the motor housing opposite each other. Fig. 53, illustrates one of the brushes removed for inspection. When the carbon on either brush is worn to 3/16" in length or if either spring or shunt wire is burned or damaged in any way, replace both brushes. If the brushes are found service- able after removing, reinstall them in the same position as removed.
Fig. 51
A
Fig. 52
F
C
E
Fig. 53
19
