UNPACKING
1.Remove the miter saw and all loose items from the carton. IMPORTANT: DO NOT LIFT THE MITER SAW
BY THE SWITCH HANDLE AS THIS MAY CAUSE MISALIGNMENT. ALWAYS LIFT THE MACHINE BY THE BASE OR CARRYING HANDLE (see (D) Fig. 4A. Fig. 2 illustrates the machine and all loose items after they have been removed from the carton.
1 - Miter Saw
2 - Dust Bag
3 - Wrench for changing the blade
4 - Clamp
5 - Table Extension (2)
| 1 |
| 5 |
2 | 4 |
|
3
Fig. 2
ASSEMBLY INSTRUCTIONS
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MITER SAW TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE ENTIRE OWNER’S MANUAL.
MOVING THE CUTTINGHEAD TO THE
RAISED POSITION
1.Push down on handle (A) Fig. 3, to release spring pressure. Then pull out cuttinghead lockpin (B) and move cuttinghead (C) to the raised position.
2.Fig. 4, illustrates the lockpin (B) pulled out and the cuttinghead (C) in the raised position.
C
B
Fig. 4
ASSEMBLING TABLE EXTENSIONS
Remove two screws from each extension rods. Assemble ends of table extension (A) Fig. 4A, onto the extension rods (B) as shown. Tighten screws (C) to hold table extension in place.
C
A
B
Fig. 3
C 
B
A
D 
6
Fig. 4A
