RAISING AND LOWERING BLADE
To raise the saw blade, loosen lock knob (A) Fig. 44, and turn the blade raising handwheel (B) clockwise. When the blade is at the desired height, tighten lock knob (A).
To lower the blade, loosen lock knob (A) Fig. 44, and turn the handwheel (B) counterclockwise. NOTE: One full turn of the handwheel will change blade height approxi- mately 1/4".
TILTING THE BLADE
To tilt the saw blade for bevel cutting, loosen lock knob
(C)Fig. 44, and turn the tilting handwheel (D). When the desired blade angle is obtained, tighten lock knob (C).
ADJUSTING 90 DEGREE AND 45 DEGREE POSITIVE STOPS
Your saw is equipped with positive stops that will quickly and accurately position the saw blade at 90 degrees and 45 degrees to the table. To check and adjust the positive stops, proceed as follows:
A
C
BD
Fig. 44
1. 
DISCONNECT MACHINE FROM
POWER SOURCE.
2. Raise the saw blade to its highest position. |
A
F
B
3. | Set the blade at 90 degrees to the table by turning |
the blade tilting handwheel counterclockwise as far as it | |
will go. | |
4. | Using a combination square (A) Fig. 45, check to |
see if the blade is at 90 degrees to the table surface as | |
shown. | |
5. | If the blade is not at 90 degrees to the table, loosen |
set screw (B) Fig. 45 with a hex wrench, and turn the | |
blade tilting handwheel until you are certain the blade is | |
at 90 degrees to the table. Turn set screw (B) clockwise | |
until it bottoms. | |
6. | Adjust the pointer (D) Fig. 46, to point to the zero |
degree mark on the scale by loosening screw (E), | |
adjusting pointer (D), and tightening screw (E). | |
7. | Turn the blade tilting handwheel clockwise as far as |
it will go and using a combination square, check to see | |
if the blade is at 45 degrees to the table. | |
8. | If the blade is not at 45 degrees to the table, loosen |
set screw (F) Fig. 45, and turn blade tilting handwheel | |
until you are certain the blade is 45 degrees to the table. | |
Turn set screw (F) clockwise until it bottoms. | |
Fig. 45
D
E
Fig. 46
21
