Functional Description, Carton Contents | Porter-Cable 36-649

FUNCTIONAL DESCRIPTION

FOREWORD

Delta Models 36-649, 36-675, 36-678 and 36-679 are 10" contractor saws. The saws have a powerful 1½ HP induction motor which can handle tough cutting operations.

A RIP FENCE ASSEMBLY IS NOT PACKAGED WITH THE PRODUCT. YOU MUST INSTALL AND USE A RIP FENCE SYSTEM FOR RIPPING OPERATIONS. SEE THE SECTION “ACCESSORIES” FOR AVAILABLE FENCE SYSTEMS.

NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE CURRENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS CONTAINED IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED TO ILLUSTRATE TECHNIQUE ONLY.

CARTON CONTENTS

TABLE SAW PARTS

1

2

3

4

7

8

9

11

5		6
			10

18




			13		15	16	17
	12		13
	12		14

				Fig. 2
1.	Table Saw		10.		Miter Gage Body
2.	Motor		11.		Miter Gage Guide Bar
3.	Pulley Guard Plate		12.		Splitter Bracket
4.	Switch Assembly		13.		Blade Guard and Splitter Assembly
5.	Lock Knob (2)		14.		Saw Blade
6.	Handwheel (2)		15.		7/8" Open End Wrench
7.	Miter Gage Handle		16.		7/8" and 1/2" Close End Wrench
8.	Motor Plate		17.		Drive Belt
9.	Motor Pulley		18.		Belt Guard

8

Image 8

Porter-Cable 36-649, 36-678, 36-675, 36-679 instruction manual Functional Description, Carton Contents

Contents

Contractor’s Saw Shown Table of Contents Important Safety Instructions Safety Guidelines Definitions California Proposition Stay ALERT, Watch What YOU are DOING, General Safety RulesImportant Safety Instructions Additional Safety Rules for Table Saws Properly Support Long or Wide workpieces Grounding Instructions Power ConnectionsMotor Specifications Volt Single Phase Operation Extension Cords Carton Contents Functional Description Sheet Metal Cast Iron Cast Iron Extension Extension Wings Extension WingsStand Parts Assembly Unpacking and CleaningAssembly Tools Required Hardware Stand Legs Stand to SAW Blade Tilting Raising Handwheel Installing Switch Motor Cord Disconnect Machine from Power Source Motor to Motor Mounting PlateMotor and Motor Mounting Plate to SAW PIN X , Through the Inside Hole of Bracket B Motor PULLEY, Pulley GUARD, and Drive Belt Connecting Motor Cord to Switch Assembly Illustrates the motor cord connected to the switch assembly Blade Guard and Splitter Assembly and Alignment Page ON/OFF Switch Model 36-649 onlyModel 36-678 only Model 36-679 only Locking Switch in the OFF Position OperationStarting and Stopping SAW Overload Protection Raising and Lowering Blade Tilting the Blade Table Insert a should Always be Level with the Table Miter Gage Operation and AdjustmentAdjusting Table Insert Changing the SAW Blade Open end wrench B Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING CROSS-CUTTING Ripping Constructing a Push Stick Accessory Moulding Cutterhead Using Moulding Cutterhead Using Accessory Dado Head Constructing a Featherboard Using Auxiliary Wood Facing on RIP FencePower Tool Institute Troubleshooting Constructing a Push Stick Warranty MaintenanceService Model Description Model 36-648 30 Fence and Rail SystemModel U30 30 Unifence Model BC30 30 Biesemeyer Commercial Fence Canadian PORTER-CABLE Delta Service Centers